12 © MARMITEK
to confirm. If you accidentally go past the code, you can stop the autosearch by pressing
Prog- [5] and by repeatedly pressing this button return to the right code. Press ENT [11] to
confirm.
! If some functions of your device do not work, you need to try another code for your brand.
The search function starts after the last confirmed code.
BRAND CODE
1 = Philips/Radiola/Aristona/Erres
2 = Sony/Panasonic/JVC/Sharp/Akai/Toshiba/Daewoo
3 = Thomson/Brandt
4 = Telefunken/Saba/Nordmende
5 = Grundig/Blaupunkt
6 = Nokia/ITT
5.4 Automatic code search for all brands
When searching an unknown code, you can step through the library automatically
(AutoSearch). When your device responds, you can stop the searching process and store the
code you found.
! You can dedicate any device (TV, DVD, SAT...) to the VCR, DVD, ASAT or DSAT buttons. You
first need to enter a code for the type of device you wish to control (from the code book),
i.e. if you want to program a SAT under the VCR button, enter ANY SAT code from the code
book and then follow the steps below:
1. Turn on the device you want to control.
2. Press and hold SETUP [7] until the LED indicator [2] stays lit. Release SETUP.
3. Press the mode button [3] that matches the device you wish to control. The LED [2] will
flash once.
4. Press Prog+ [5] once. After a few seconds the remote control will start stepping through
the code library (fast search, 1 code per second). When the device responds, you can press
Prog+ [5] to switch to slow search (1 code per 3 seconds). You can step back by pressing
Prog- [5] (you can step forward by pressing Prog+ [5] in case you went back too far). As
soon as the device responds again, press ENT [11] to store the code you found.
! if some functions of your device do not work, you need to try another code for your brand.
The search function starts after the last confirmed code.
5.5 Manual code search
Note: You can dedicate any device (TV, DVD, SAT...) to the VCR, CBL, DVD, CD, ASAT, DSAT or
AUX buttons. You first need to enter a code for the type of device you wish to control (from
the code book), i.e. if you want to program a SAT under the AUX button, enter ANY SAT code
from the code book and then follow the steps below:
