613359

Marmitek MegaView 66 Manual

5
Zoom out
Zoom in
Previous page
1/40
Next page
MegaView 65/66™ 5
ENGLISH
5. SETTING SIGNAL STRENGTH
The MegaView™ 66 is equipped with an automatic signal strength controller.
With the MegaView 65
™, you can adjust the signal strength manually, using the
''Length'' button [8]. This function uses 12 positions. Once you pass position 12, you
automatically start again at position 1. When the function is at position 1, the LED will
turn red [9].
1. Sequentially push the button until the LED turns red (position 1).
2. Now, successively press the button until you have the best image display.
3. The settings will be saved when you switch off the MegaView 65.
6. INSTALLATION IR RETURN (MEGAVIEW 66™)
The MegaView 66™ has a built-in “infrared return channel”, which allows you to
operate the connected device from another room or through closed cabinet doors
using your own remote control.
1. Connect the IR receiver to the MegaView 66™ receiver [5].
x Position it so that it is visible to your (infrared) remote control, allowing it to
receive the transmitted commands (up to 6 metres).
x The most logical place for the IR receiver is in the vicinity of your display device
(HDTV or projector).
x By using the supplied adhesive strip, placement is possible virtually anywhere.
x Experiment to find the right position before definitive attachment of the IR blaster
LED.
Attention! The adhesive strip may cause discolouration on certain surfaces, or may
leave adhesive residue when removed.
2. Connect the IR extender cable to the MegaView 66™ transmitter [6].
x Stick the IR blaster LED near the HDMI source.
x When positioned correctly, one blaster LED can operate all A/V devices within
the same compartment of a cabinet.
x Experiment to find the right position before definitive attachment of the IR
receiver.
Attention! The adhesive strip may cause discolouration on certain surfaces, or may
leave adhesive residue when removed.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marmitek MegaView 66 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marmitek MegaView 66 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info