Manual Marmitek IR Control 10 XTRA (page 9 of 68) (English, German, Dutch, French, Italian, Spanish)

613325

Zoom out

Zoom in

1/68

IR CONTROL 10/11 XTRA™ 9

ENGLISH

6. ADVANCED INSTALLATION

6.1 Connecting multiple IR receivers

If you want to operate your A/V equipment from multiple rooms, you can

connect up to 6 IR receivers in parallel to the IR module. Cut therefore the

standard connector of the IR receiver and connect it to the SCREW

TERMINAL of the IR module (see paragraph 4.1).

6.2 Extend the cable length of the IR receiver

Only the cables between the IR receiver and the IR module can be

extended. The IR cables with emitter or blaster LEDs cannot be extended.

Place the IR module as close as possible to your A/V equipment and extend

the cable between the IR receiver and the IR module if needed to a

maximum of 300 meters with CAT5 cable (or equal). Cut the standard

3.5mm connector off the IR receiver cable and extend the cable according

to the example below.

IR receiver

CAT5 cable

IR module

Red

Orange

+12VDC

Black

Blue

GND

Yellow

Green

STATUS

White

Brown

IR DATA

6.3 Connecting AVR connection cable

A/V equipment from different brands (for

instance Denon, Yamaha, Onkyo, Marantz,

etc) have a direct “IR IN” connector at the

back. A direct connection with the AVR

connection cables is an alternative way of

connecting your A/V equipment. The use of

an IR extension cable (with emitter or blaster LED) is not necessary here.

Note; check the technical documentation of your equipment to decide

whether the IR module of the IR control 10/11 XTRA can be connected

directly. Most IR cables use a 3.5mm mono jack connector where the tip is

used for the “IR Data” and the sleeve for “GND”.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Marmitek IR Control 10 XTRA in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Marmitek IR Control 10 XTRA Manual

Product: