613325

Marmitek IR Control 10 XTRA Manual

8
Zoom out
Zoom in
Previous page
1/68
Next page
8 © MARMITEK
5.4 Locating the IR Module
Mount the IR Module at an accessible place behind or alongside your A/V
equipment, in the vicinity of an electrical socket.
x Be aware of the cable length of the IR LEDs and the IR receiver.
x Make sure the connections for installation remain accessible.
5.5 Connecting the IR Module
1. Connect the installed IR extension cables to the ‘IR OUT’ connector of
the IR Module.
2. Switch only the switches of the IR Module in BLASTER mode if an IR
extension cable with one blaster LED is connected. In any other case,
leave the switch in the EMITTER mode.
NOTE: a wrong choice between the two possibilities can cause
damage to the IR LEDs and they can even become defective.
3. Connect the installed IR receiver cable to the ‘IR RCVR’ connector of
the IR Module.
4. Connect the power adapter to the ‘12VDC’ connector of the IR Module
and connect it to the mains.
5.6 Perform a function test of the product
1. If the IR Control 10/11 XTRA™ is properly connected, the light on the
IR receiver flashes if you push a button on the (infrared) remote control
and aim it towards the IR receiver.
2. Close the doors of your cabinet and make sure the A/V equipment
cannot receive an infrared command directly from the remote control.
Otherwise this could lead to operating problems.
3. You can now operate your A/V equipment via the IR Control 10/11
XTRA™ through the closed cabinet doors!
If the IR Control 10/11 XTRA is not reacting in a correct way, try
experimenting with the placement of the IR receiver and/or IR extension
cables (emitter or blaster). Placing it somewhere else could give a better
result.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marmitek IR Control 10 XTRA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marmitek IR Control 10 XTRA in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 0,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info