4 MARMITEK
How does it work?
Plug in the power adapter or insert the 9V battery (not included) and place
the Invisible Control within sight, on or below the cupboard that the A/V
equipment is in. Stick the IR LEDs on the IR eye of your equipment and then
wire these to the Invisible Control. The Invisible Control now receives the sig-
nal from your own remote control and transmits it to the IR LEDs connected
to your equipment. You can now use your own remote control to operate
your equipment while it is still placed in a closed cupboard.
Installation
1. Plug the power adapter into the left side of the Invisible Control
(see image 1) or insert a 9V battery (not included) in the battery
compartment of the Invisible Control. Check the polarity.
2. Connect the wire with the two IR LEDs (the IR extender) to the
rightside of the Invisible Control. It doesn’t matter whether you use the first
or the second connection. (see image 2)
3. Place the Invisible Control within sight and within reach of your remote
control (max. 8 m) on or below the cupboard the equipment is in.
TIP: You can also stick the Invisible Control to the bottom or side of the
cupboard using double-sided tape, or screw it to the bottom of the cupboard
using the screw holes in the lid of the battery compartment. This allows you
to easily remove and reattach your Invisible Control.
4. Lead the wire with the IR LEDs (the IR extender) to the A/V
equipment in such a way that the IR LEDs (transmitters) are on the front
of your equipment (e.g. via the back of the cupboard). The IR
LEDs have self-adhesive tape on the back. Use this to stick them onto
the IR eye of your equipment. This should be done very carefully
and precisely. Test the position of the IR LEDs first, before you stick them
onto the eye.
ATTENTION: If you are only using one appliance, then you do not need to
use the second IR transmitter. Never remove it from the wire!
TIP: If you want to control more than two appliances, you can purchase an
extra IR extender cable (IR Eye, article number: 09682) and plug this into the
other connection.
5. The Invisible Control receives the signal from your remote control and
transfers it to an electrical signal, which is passed on to the two IR LEDs.
6. This means all signals from your remote control are passed on to your
equipment.
