494238
5
Zoom out
Zoom in
Previous page
1/44
Next page
3.3 Connect infrared blaster (if necessary)
Plug the IR LED Extender cable into the IR OUT connector on the GV821 Transmitter. Attach
the IR LEDs to the front of your HD devices. This will now send all received infrared com-
mands via the IR Sensor from the GV821 Receiver.
NOTE: The IR Sensor Extender cable supports 36kHz to 56kHz (NEC, RC5, RC6)
infrared remote controls. Some devices may not be supported.
4. OPERATION
4.1 Using the GigaView 821 set
1.Place two AAA batteries in the Remote Control.
2.Once the Power Supply has been inserted into the socket, the GV821 will switch itself ON.
If the GV821 set is in Standby mode (POWER LED is red), press the ON/OFF button on the
GV821 Transmitter and Receiver to switch them on. It takes about 80 seconds for the sys-
tem to start up.
While warming up, the Power LED will flash blue until the signal connection between the
Transmitter and Receiver has been established.
NOTE: the Transmitter and Receiver must be at least 2 metres apart to have a good
connection.
HDMI
IR Led Extender cable
Blu-Ray Player
IR Sensor
HD Media Player
5GIGAVIEW 821
ENGLISH
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marmitek GigaView 821 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marmitek GigaView 821 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info