571035
15
Zoom out
Zoom in
Previous page
1/20
Next page
MAINTENANCE
CLEANING
The satin gold anodized finish of the knobs and
heavy aluminum front panel will last indefinitely
with proper care and cleaning.
NEVER use
scouring pads, steel wool, scouring powders, or
harsh chemical agents, such as lye solution. These
will mar the finish. Clean with a soft, lint-free
cloth or cotton swab slightly dampened with a
mild solution of detergent and water.
FUSE REPLACEMENT
The Model 2252 is protected by a 2 amp 250 V
fuse. In the event the fuse blows out, replace it
ONLY with a fuse of the same type and rating.
Replacement with a fuse of higher rating will not
protect the instrument and will void the warranty.
IN CASE OF DIFFICULTY
If the receiver and the dial lamps do not operate,
make sure the power cord is connected. If the
power cord is all right and your unit is equipped
with an external AC line protector fuse, check the
fuse and replace it if necessary. If the dial lamps
are properly illuminated but one channel is
inoperative, check the loudspeaker cord of the
inoperative channel for a short circuit, broken
wire, loose connection or other fault. If the loud-
speaker connections appear satisfactory, check
for a broken, open, shorted, corroded, or discon-
nected shielded cable between the receiver and
the input equipment. Check for improper setting
of the
BALANCE control. Look for any other
visible fault. If no fault is noted, turn off the
audio system, then transpose (left for right) the
shielded source input cables at the receiver. If the
opposite channel becomes inoperative when
turned back on, then either the shielded cable or
the input equipment is at fault. If the same
channel remains inoperative, turn off power and
similarly transpose the loudspeaker cords. If,
when the system is turned on, there still is no
sound from the same speaker system, then either
the loudspeaker system or the loudspeaker cord is
at fault. If the opposite speaker system fails to
operate, then the receiver is inoperative. Refer the
problem to your nearest authorized Marantz
Service Facility.
SPECIFICATIONS GENERAL
Amplifier Section:
65W
0.1%
8 OHMS
52 WATTS
20 Hz to 20 kHz
....................... .; '" .
RATED POWER OUTPUT,
MINIMUM CONTINUOUS
AVERAGE POWER PER
CHANNEL, BOTH CHANNELS
DRIVEN
POWER BAND
TOTAL HARMONIC
DISTORTION
LOAD IMPEDANCE
RATED POWER OUTPUT,
MINIMUM CONTINUOUS
AVERAGE POWER PER
CHANNEL, BOTH CHANNELS
DRIVEN INTO 4 OHM
IMPEDANCE LOADS
11
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Marantz Model 2252 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Marantz Model 2252 in the language / languages: English as an attachment in your email.

The manual is 12,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info