Manual Marantec Control x.51 (page 50 of 58) (English)

742782

Zoom out

Zoom in

1/58

10. Messages

10.3 Rectifying faults

Error Cause Solution

LED 8 does not light up. - No voltage. - Check that the mains power supply is operational.

- Check the connection to the mains power supply.

- Thermal overload protection in power

transformer was activated.

- Allow the power transformer to cool down.

- Defective control unit. - Have the operator system checked.

No reaction on impulse. - The connection terminals for the

“impulse” button were by-passed,

e.g. due to a short-circuit or flattened

terminals.

- Try temporarily disconnecting any key switches or interior

push buttons that are connected to the control unit

(Section 6.7):

Remove the lead from socket XB99 and then bridge

terminals B9 and 5; insert jumper plug and check for

cabling errors.

No reaction on impulse from

hand transmitter.

- Module antenna is not plugged in. - Connect the module antenna to the control unit

(Section 8.1).

- The hand transmitter coding does not

correspond to the receiver coding.

- Activate hand transmitter again (Section 8.5.3).

- Hand transmitter battery is empty. - Insert new battery (Section 7.1).

- Defective hand transmitter, control

unit electronics or module antenna.

- Have all 3 components checked.

10.3.1 Malfunctions without error messages

50 Operating Instructions, Comfort 580 GB (#91636)

Legend:

LED off

LED on

LED flashes slowly

LED pulses

LED flashes quickly

Factory default setting

Not possible –

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Marantec Control x.51 in the language / languages: English as an attachment in your email.

The manual is 3,38 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Marantec Control x.51

Marantec Control x.51 User Manual - German - 58 pages

Marantec Control x.51 User Manual - French - 58 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Marantec Control x.51 Manual

Product: