448644

Makita SC 190DW Manual

9
Zoom out
Zoom in
Previous page
1/76
Next page
(Fig. 4 for SC190DW)
1. Plug the battery charger into your power source. The charging light will flash in green color.
2. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same
sides as their respective markings on the battery charger. Insert the cartridge fully into the port so that it
rests on the charger port floor.
3. When the battery cartridge is inserted, the charging light color will change from green to red and charging
will begin. The charging light will keep lighting up steadily during charging.
4. When charging is completed, the charging light color will change from red to green.
5. After charging, unplug the charger from the power source. The charging time is as follows:
Battery type Capacity (mAh) Number of cells Charging time
1822 2,000 15 Approx. 60 min.
1833 2,200 15 Approx. 65 min.
1834 2,600 15 Approx. 75 min.
1835 3,000 15 Approx. 90 min.
CAUTION for SC130DRA and SC160DRA:
•
The fast charger Model DC1439/DC1209 is for charging Makita battery cartridge. Never use it for other
purposes or for other manufacturer’s batteries.
•
When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of
time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can
recharge the battery cartridge fully after discharging it completely and recharging a couple of times.
•
If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a
location exposed to direct sunlight or heat for a long time, the charging light may flash in red color. If this
occurs, wait for a while. Charging will begin after the battery cartridge cools.
•
If the charging light flashes alternately in green and red color and tone will sound ‘‘beep, beep, beep, ....’’ for
about 20 seconds, a problem exists and charging is not possible. The terminals on the charger or battery
cartridge are clogged with dust or the battery cartridge is worn out or damaged.
•
If charging two or more battery cartridges in succession with fast charger DC1209, the charging time may
become longer to protect the charger.
CAUTION for SC190DW:
•
The battery charger Model DC1801 is for charging Makita-battery cartridge. Never use it for other purposes
or for other manufacturer’s batteries.
•
When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of
time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can
recharge the battery cartridge fully after discharging it completely and recharging a couple of times.
•
If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a
location exposed to direct sunlight or heat for a long time, the charging light may flash in red color. If this
occurs, wait for a while. Charging will begin after the battery cartridge cools.
•
If the charging light flashes alternately in green and red color, charging is not possible. The terminals on the
charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged.
•
If you wish to charge two battery cartridge, allow 15 minutes between chargings on the battery charger.
•
Any of the following conditions indicates damage to the charger and/or battery cartridge. Ask your Makita
Authorized or Factory Service Center to check them.
1) The charging light does not flash (green) when the battery charger is plugged into a power source.
2) The charging light does not light up or flash (red) when the battery is inserted in the charger port.
3) Charging is not completed at even more than two hours after red light comes ON at start of charging.
Installing or removing cutters
(Fig. 5 for SC130DRA, Fig. 6 for SC160DRA and Fig. 7 for SC190DW)
CAUTION:
Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing
the cutters.
SC130DRA/SC160DRA/SC190DW (E) (’100. 1. 27)
9
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita SC 190DW at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita SC 190DW in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 0,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Makita SC 190DW

Makita SC 190DW User Manual - English, Dutch - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info