598974

Makita PTR2500 Manual

10
Zoom out
Zoom in
Previous page
1/98
Next page
10
FUEL/REFUELING
Gasoline/oil mixture
- The engine of the pole hedge trimmer is a highly efficient two-stroke engine that
runs on a mixture of gasoline and two-stroke engine oil. The engine is designed
to use regular unleaded gasoline with a min. octane value of 91 ROZ. If such
gasoline is not obtainable, instead use gasoline with the highest octane value
available. This will not cause any damage to the engine, but may result in poor
engine performance. Similar results are to be expected when leaded gasoline is
used. To obtain optimal engine performance, and for the sake of human health
and the environment, where possible use unleaded fuel.
- Two-stroke engine oil (quality grade: TSC-3) must be added to the gasoline in
order to lubricate the engine. The engine has been designed to use environment-
friendly MAKITA 2-stroke oil, which is to be mixed at a ratio of 50:1. This
specially developed oil ensures prolonged engine service life and reliable engine
performance with an absolute minimum of exhaust gas emissions. It is imperative
to strictly observe the 50:1 mixture (Gasoline/MAKITA 2-stroke oil), as reliable
performance of the pole hedge trimmer cannot be guaranteed otherwise.
- Correct gasoline/oil mixture:
Mix 50 parts gasoline with 1 part MAKITA 2-stroke engine oil (see also table on
the right).
NOTE: When preparing the gasoline/oil mixture, first mix all of the amount of oil
required with half the amount of gasoline required. Add the remaining
gasoline and shake the mixture well before replenishing the tank.
Do not add more oil then prescribed. If too much oil is added this will
produce additional combustion residue, thus polluting the environment and
clogging the muffler and the cylinder exhaust channel. In addition, overall
fuel consumption will also increase and poorer engine performance is to
be expected.
Handling of petroleum products
Always handle fuel with the utmost care and attention. Since fuel contains
substances similar to solvents, refueling must be done outdoors or in well-
ventilated areas. Do not inhale gasoline fumes and avoid any skin contact with
gasoline or oil. Human skin will dry out if in contact with petroleum over an
extended period of time. This may result in various skin diseases and allergic
reactions.
Gasoline or oil coming into contact with the eyes can cause severe eye irritation.
Should gasoline or oil come into contact with your eyes, immediately rinse your
eyes with large amounts of clean water. Do not hesitate to see a doctor if irritation
persists.
Observe the Safety Instructions on page 5
Gasoline Oil
1000mL (1L)
5000mL (5L)
10000mL (10L)
20mL
100mL
200mL
50
Refueling
The engine must be switched off.
- Thoroughly clean the area around the fuel filler cap (2), to prevent dirt from
getting into the fuel tank (1).
- Unscrew the fuel filler cap (2) and fill the tank with fuel.
- Tightly screw on the fuel filler cap (2).
- Clean screw fuel filler cap (2) and tank after refueling.
Fuel storage
- Fuel deteriorates if stored over an extended period of time.
- Purchase only the amount of fuel to be used over a 4-week period.
- Use only approved petroleum-storage containers.
Û
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita PTR2500 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita PTR2500 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info