Manual Makita HTR 7610 (page 13 of 86) (English, German, Dutch, French, Italian, Spanish)

476899

Zoom out

Zoom in

1/86

Checking and adjusting the idling speed

The cutting blade should not when the control lever is fully released.

– Idle speed should be set to 2,600 rpm.

If necessary, correct it by means of the idle screw (the cutting blade

must not run when the engine is on idle).

• Clockwise : for faster rate of revolution

• Counter-clockwise : for slower rate of revolution Check that there is

sufficient difference between idling and clutch engagement speed

to ensure that the cutting tool is at a standstill while the engine is

idling. (If necessary, reduce idling speed.) If the tool still

continues to run under the idling conditions, consult your nearest

authorised service agent.

• The clutch should engage at minimum 3,250 rpm.

• Check the functioning of the STOP Switch, the lock-off lever, the

control lever, and the lock button.

Cleaning of air cleaner - Every 8 hours (Daily)

– Remove the air cleaner cover.

– Take out the sponge element, wash it in lukewarm water and dry it

completely.

– After cleaning, put back the sponge element and the air cleaner

cover.

NOTE:

If there is excessive dust or dirt adhering to the air cleaner,

clean it every day. A clogged air cleaner may make it

difficult or impossible to start the engine or increase the

engine rotation speed which could cause damage.

Checking the spark plug - Every 8 hours (Daily)

– Only use the supplied universal wrench to remove or to install the

spark plug.

– The gap between the two electrodes of the spark plug should be 0.6

to 0.7mm. If the gap is too wide or too narrow, adjust it. If the

spark plug is clogged with carbon or fouled, clean it thoroughly or

replace it. Use an exact replacement.

Supply of grease and lubricant

– Supply grease to the gear case through the grease hole every 10 to

20 hours. (Shell alvania No.3 or equivalent)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Makita HTR 7610 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1,72 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Makita HTR 7610 Manual

Product: