Manual Makita EW120R (page 29 of 152) (English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish)

599905

Zoom out

Zoom in

1/152

ENGINE OIL CHANGE (See Fig.

Initial oil change : After 20 hours of operation

Thereafter : Every 100 hours of operation

(1) When changing oil, stop the engine and loosen the drain

plug. Drain the used oil while the engine is warm. Warm

oil drains quickly and completely.

(3) Refer to page 6 for the recommended oil.

Always use the best grade and clean oil. Contaminated

oil, poor quality oil and shortage of oil cause damage to

engine or shorten the engine life.

(4) Procedures for EW120R

1) Remove the oil gauge. Be cautious to place the oil

gauge in a place where it will not gather dirt, dust or

other foreign matter. (See Fig.7

q Oil gauge

2) Place a cloth or paper towel to the area around the

oil filler hole. (See Fig.7

t, q)

3) Remove the oil gauge, then tilt the engine and drain

the oil into a pan or other receptacle. (See Fig.7

4) Put the engine on a level surface, then fill with the oil up

to the point of overflowing the filler neck. Pour the oil in

from a squeeze bottle or other appropriate. (See Fig.

5) After filling the engine with oil, reinsert the oil gauge.

Ensure that the oil gauge is tight, as if it loosens later

oil will leak out.

(2) Re-install the drain plug before refilling oil.

To prevent injury, pay attention to the hot oil.

Make sure the fuel cap is tightly secured to

avoid spillage.

CAUTION

Oil CapacityModel

EW120R 0.08L

EW220R

EW220ST

EW320R

EW220TR

0.6L

EW320TR 1.0L

5. CLEANING FUEL FILTER

(See Fig.

i) (EW120R)

WARNING Flame Prohibited

Remove the hose clamp and pull out the fuel filter from fuel

pipe. Wash the fuel filter with kerosene. After washing,

reassemble it. If the fuel filter is heavy dirty, replace it with

new one.

Explanation of Fig.

q Fuel filter w Fuel pipe e Hose clamp

(1) Inspect fuel cup for water and dirt.

(See Fig.7

o q)

(2) To remove water and dirt, close the fuel cock and

remove the fuel cup.

(3) After removing dirt and water, wash the fuel cup with

kerosene or gasoline. Reinstall securely to prevent

leakage.

WARNING

Flame Prohibited

6. CLEANING FUEL CUP

(See Fig.

o) (Except EW120R)

Normal idling rpm 3000

100rpm

ADJUSTING IDLING RPM. (CARBURETOR)

(See Fig.

!0!0

!0) (EW120R)

When adjust screw is turned right, engine rpm increases, and

when it is turned left, rpm decreases. (Refer to illustration.)

NOTE

The carburetor greatly affects the performance of the

engine.

Since it has been adjusted carefully at our factory before

shipment, avoid adjusting unless absolutely necessary. If

adjustments are needed, contact your nearest dealer.

A dirty air cleaner element will cause starting difficulty, power

loss, engine malfunctions, and shorten engine life extremely.

Always keep the air cleaner element clean.

WARNING

Flame Prohibited

8. CLEANING AIR CLEANER

(See Fig.

!1!1

!1~

!4!4

!4)

EW120R (See Fig.

!1!1

!1,

!2!2

!2)

q Fixing bolt

w Air cleaner cover

e Choke lever

r Element

[Place so that the cutout is here (top left)]

t Breather

Remove the fixing bolt of air cleaner cover.

(See Fig.7

Pull out the lower edge of the cover to remove the air

cleaner cover. (See Fig.7

Place the choke lever to the fully closed position, taking

care to ensure that dust and dirt are not allowed to enter

the carburetor.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Makita EW120R in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,48 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Makita EW120R Manual

Product: