690576

Makita EM2654LHC Manual

16
Zoom out
Zoom in
Previous page
1/84
Next page
16
Nylon cutting head operation
The nylon cutting head is a dual string trimmer head provided with a bump &
feed mechanism.
To cause the nylon cord to feed out, tap the cutting head against the ground
while rotating.
The most effective cutting area is shown by the shaded area.
NOTE:
If the nylon cord does not feed out while tapping the head, rewind/replace the
nylon cord by following the procedures described under “Maintenance”.
1
(1)
CAUTION:
Holdthemachinermlywhenstartingtheengine.Otherwisefallingmachinemayresultinpersonalinjury.
Observe the applicable accident prevention regulations!
Starting
Move at least 3 m away from the place of refuelling. Place the Petrol Brushcutter on a clean piece of ground taking care that the cutting tool
doesnotcomeintocontactwiththegroundoranyotherobjects.
A: Cold start
1) Setthismachineonaatspace.
2) Set the I-O switch (1) to operation position.
3) Primer pump
Continue to push the primer pump until fuel enters into the primer pump (1).
(In general, fuel enters into the primer pump by 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
4) Recoil starter
Pull the start knob gently until it is hard to pull (compression point). Then,
return the start knob, and pull it strongly.
Never pull the rope to the full. Once the start knob is pulled, never release
your hand immediately. Hold the start knob until it returns to its original
point.
5) Warm-up operation
Continue warm-up operation for 2 to 3 minutes.
POINTS IN OPERATION AND HOW TO STOP
… 16 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita EM2654LHC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita EM2654LHC in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 17,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info