690931
7
Zoom out
Zoom in
Previous page
1/17
Next page
6 ENGLISH
1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indicate
the remaining battery capacity. The indicator lamps light
up for few seconds.
14.4V/18V batteries
Indicator or lamps
Remaining Capacity
Lighted Off Blinking
75%
100%
50%
75%
25%
50%
0%
25%
Charge the battery
The battery may
have malfunctioned
10.8V-12V max batteries
Indicator or lamps
Remaining Capacity
Lighted Off Blinking
75%
100%
50%
75%
25%
50%
0%
25%
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
Using Supplied AC power
adaptor (Fig. 5)
Remove the rubber protector and insert the adaptor plug
into the DC socket on the right side of the speaker. Plug
the adaptor into a standard mains socket outlet. Whenever
the adaptor is used, the battery pack is automatically
disconnected. The AC adaptor should be disconnected
from the main supply when not in use.
IMPORTANT:
The mains adaptor is used as the means of connecting
the speaker to the mains supply. The mains socket
used for the speaker must remain accessible during
normal use. In order to disconnect the speaker from
the mains completely, the mains adaptor should be
removed from the mains outlet completely.
Use the AC power adaptor supplied with the product or
specied by Makita only.
Do not hold the power supply cable and plug by your
mouth. Doing so might cause an electric shock.
Do not touch the power plug with wet or greasy hands.
If the cord is damaged, have it replaced by our
authorized service center in order to avoid a safety
hazard. Do not use it before repair.
After use, always store AC power adaptor out of the
reach of children. If Children play with the cord, they
may suffer injury.
USB power supply socket
This jack can be used to charge a mobile phone or any
other device that uses less than 2.1A of DC current.
Charging will only occur when the speaker is switched on.
Note: Ensure the specication of your external device
such as mobile phone, mp3 player or iPod is compatible
with the speaker. Please read instruction manual of your
external device before charging.
IMPORTANT:
Before connecting USB device to the charger, always
backup your data of USB device. Otherwise your data
may lose by any possibility.
The charger may not supply power to some USB
devices.
When not using or after charging, remove the USB
cable and close the cover.
Do not connect power source to USB port. Otherwise
there is risk of re. The USB port is only intended for
charging lower voltage device. Always place the cover
onto the USB port when not charging the lower voltage
device.
Do not insert a nail, wire, etc. into USB power supply
port.
Otherwise a circuit short may cause smoke and re.
Do not connect this USB socket with your PC
USB port,
as it is highly possible that it may cause breakdown of
the units.
Pairing and connecting a device
to the speaker
You need to pair your Bluetooth device with the speaker
before you can auto-link to play/stream Bluetooth music
through the speaker. Pairing creates a `bond' so two
devices can recognize each other.
To have the better sound quality, we recommend setting
the volume to more than two-thirds level on your Bluetooth
device and then adjust the volume on the speaker as
required.
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Makita DMR202 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Makita DMR202 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Turkish, Spanish as an attachment in your email.

The manual is 5,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info