Manual MakerBot Replicator 2 - MB1036 (page 14 of 60) (English)

534674

Zoom out

Zoom in

1/60

INSTALLING BUILD PLATE

B SETTING UP YOUR MAKERBOT REPLICATOR 2 DESKTOP 3D PRINTER

5a. Use strong scissors or a wire cutter to

cut the zip ties holding the gantry system

in place. Discard the zip ties and the plastic

pieces holding them in place.

NOTE: Operate scissors with care.

5b. A small plastic piece attached to the

X-axis belt and gantry rods prevents the

extruder from moving. Carefully snap the

piece o of the rods and tilt it to slide it o

of the belt.

Freeing the Extruder

4a. Locate and unwrap the build plate. Tilt

and ﬁt the notch in the build plate onto the

tab at the back of the build platform. Fit the

tab in the build plate between the two pegs

at the front of the build platform.

4b. To remove the build plate, gently push

the tab on the front of the build plate

toward the back of the build platform

to release the tab from the pegs. Lift

the build plate from the build platform.

Installing the Build Plate

Plate-Locking Pegs

MB2020_REP2_UserManual_V4.indd 14 7/22/13 5:32 PM

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of MakerBot Replicator 2 - MB1036 in the language / languages: English as an attachment in your email.

The manual is 3,42 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of MakerBot Replicator 2 - MB1036

MakerBot Replicator 2 - MB1036 User Manual - German - 45 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

MakerBot Replicator 2 - MB1036 Manual

Product: