616524
93
Zoom out
Zoom in
Previous page
1/156
Next page
Plug-ins 93
In VCA mode, the control signal is accessed at the input where it firstly executes a
controllable low-cut (which may be set up via "detector hp freq" in "Expert" mode).
The filter makes sure that deep-frequency signals have less influence on the
adjustment settings; this is a popular trick for more power, e.g., when using drums in a
sub-group.
The filtered signal then arrives at the detector. With the forward gain control,
previously set parameters apply fully and affect the adjustment settings immediately.
In contrast to this, there is a "feedback" method which provides a second compressor
mode.
Compression Parameters
Vintage Mode
In this mode, you can intuitively (by ear) use the dynamic editing features with just
three knobs. Do whatever you want, but keep in mind: less is sometimes more...
Drive: You can use the "drive" potentiometer to control the amplification factor in
the feedback loop, i.e. the signal strength which the detection circuit calculates.
Furthermore, the internal "ratio" changes within a limit, the more "drive" there is,
the higher the compression ratio.
Attack and release: The same basic conditions as VCA mode apply here.
However, not only do you change the actual control response time after
detection, but the "temporal window" in the detector must be adjusted as well.
Additionally, the feedback method does cause a certain amount of
unpredictability. You should expect less control over the device in this mode, but
more leniency on its part.
VCA Mode
The regular set of parameters of dynamic compressors is available in this mode:
93


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Magix Audio cleaning lab 2014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Magix Audio cleaning lab 2014 in the language / languages: English as an attachment in your email.

The manual is 12,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info