616524

Magix Audio cleaning lab 2014 Manual

86
Zoom out
Zoom in
Previous page
1/156
Next page
86
www.magix.com
Optionally inside the essentialFX_TubeStage plug-in, either one or two tube stages
work.
Tube circuits, especially if they work in the border area and saturate/distort the signal
with the gain control, react very sensitively to the input signal's spectral composition.
Two independent filter circuits accompany this plug-in's tube stage (s). The first (pre-
eq) acts directly on the input signal. With this you can determine which frequency
range should be principally edited. The second filter circuit (post-eq) is located
behind the tube stage (or after the second) and determines the tonal balance of the
output signal.
This enables you to create various sound nuances. For example, you can accentuate
the high frequency range on the input side, for example, to create Exciter-/Enhancer
effects, so that the signal appears more "tangible". To avoid overemphasizing this
amplified range, a reverse process with the post-EQ can be subsequently made.
Both of the available tube stages can be globally switched in the A or AB operation. In
the A-circuit the entire signal runs through, as is common with simple tube preamps,
through a tube. However, since these can only edit a half-wave, the working point of
the circuit is set approximately in the middle of the reference line. However neither
halve will ever be treated equally, so that positive displacements are amplified
differently to negative displacements. (so-called Class A operation). Thereby odd and
even harmonics are created. The typical 'warm' tube sound to a large extent dates
back to the characteristic overtone spectrum.
For each half-wave in class-AB operation, a separate tube is used, so that in principle
there is a symmetrical reinforcement. The signal contains predominantly uneven
harmonics. The sound image appears thinner but more transparent and solid. This is
comparable to the sound, that tape machines create when they are slightly
overmodulated.
… 86 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Magix Audio cleaning lab 2014 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Magix Audio cleaning lab 2014 in the language / languages: English as an attachment in your email.

The manual is 12,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info