450951

Maclaren Easy Traveller Manual

6
Zoom out
Zoom in
Previous page
1/19
Next page
A
Graco SnugRide
Graco SnugRide 32
A
Peg Perago Primo
ViaggioSIP 30.30
B
Peg Perago Primo
Viaggio Latch System
C
Evenflo Discovery
A
Baby Trend Flex Loc
A
4
5 TO ADAPT THE MACLAREN EASY TRAVELLER TO YOUR
INFANT CAR SEAT
A ADJUST YOUR CROSSBAR: Use a cross-headed
(phillips) screwdriver and pliers remove the screws,
locknuts and washers. Slide the front cross bar to the
correct height (A, B or C) and reinsert screws and attach
washers and locknuts. Tighten the screws into the
locknuts until resistance is felt, then firmly continue
tightening for two turns to lock the screws.
1. For the Chicco Keyfit 30 and the Britax Chaperone Car
seat, the Special Adaptor Bar MUST be used. Do not
use the bar that is already attached to the stroller.
This means you MUST remove the existing bar, by loosening
the screw on both end caps located at the top of the post.
Take off the end cap, and remove the existing adaptor bar.
2. Now attach the Special Adaptor Bar at the (A)position
as explained above. Replace the end caps; tighten the
screws into the end cap.
NOTE: MAKE SURE THE DIRECTION OF THE BAR IS CORRECT -
REFER TO THE LABEL ATTACHED ON THE ADAPTOR
B PLACE THE CAR SEAT: Gently lower the car seat onto the
buggy frame. It must be oriented so that the child will
face the rear of the Maclaren Easy Traveller. This means
the child will face the Parent or Care Giver. Attach the
straps. Remember the straps are critical to prevent your
child’s car seat from sliding or falling out of the Maclaren
Easy Traveller stroller. The first time you do this, you will
need to adjust the car seat straps to the proper length for
a secure fit around the car seat.
IMPORTANT: The positioning of the adaptor bar is specific
to your car seat. Only the approved car seats illustrated in
the diagrams page can be used with this Easy Traveller.
ASSEMBLY INSTRUCTIONS
INFANT CAR SEAT MODELS
WARNING - FALL HAZARD:
AVOID SERIOUS INJURY
BY USING THE WRONG CAR
SEAT. ONLY CAR SEATS
LISTED BELOW CAN BE USED:
INFANT CAR
SEAT MODEL
FRONT CROSS
BAR POSITION
Britax Chaperone A (Special Adaptor Bar)
Graco SnugRide A
Graco SnugRide32 A
Peg Perago Primo Viaggio Latch System C
Peg Perago Primo ViaggioSIP 30.30 B
BabyTrend Flex Loc A
Evenflo Discovery A
Chicco KeyFit 30 A (Special Adaptor Bar)
Each type of car seat has a unique Front Cross Bar position.
Find your Bar position below. For each car seat there is a specific
diagram to follow for each instruction. Find the right diagram
for your car seat.
… 6 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Maclaren Easy Traveller at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Maclaren Easy Traveller in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 3,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info