167699
14
Zoom out
Zoom in
Previous page
1/80
Next page
14
GB
4.2 AUDIO CABLES
When installing the audio cable between the cinch output of your car receiver and the
cinch input of the amplifier inside your car, the audio and power supply cables should,
wherever possible, not be routed along the same side of the vehicle. We recommend an
isolated installation, e.g. routing the power cable through the cable duct on the left-hand
side and the audio cable through the cable duct on the right-hand side or vice versa. This
reduces interference due to crosstalk into the audio cables.
4.3 LOUDSPEAKER CONNECTIONS
In normal operating mode (i.e. one loudspeaker on each individual amplifier
channel), the lowest terminal resistance is 2 ohm per channel.
In bridging mode (two amplifier outputs combined) the lowest terminal resistance
doubles to 4 ohm.
The impedance in tri-mode may not fall below 2 ohm per channel.
Never connect the loudspeakers' minus terminals to the vehicle chassis.
Never connect the +12 V supply voltage to a loudspeaker output as this would
destroy the amplifier final stage.
If the amplifier is operated with lower terminal resistances or incorrectly used as
described above, both the amplifier and the loudspeakers may be damaged. The
warranty becomes void in such cases.
5. OPERATING ELEMENTS AND IN/OUTPUTS
5.1 SETTING THE INPUT SENSITIVITY
The input sensitivity may be adapted to any car radio or tape deck. Turn the volume
control of your radio to its central position and then adjust the input-level control (3) to
produce an average medium volume. This setting usually provides sufficient power
reserves at optimum weighted noise voltage.
ATTENTION: only reproduce loud test noises briefly to prevent damaging the
loudspeakers.
5.2 LOW-PASS FILTER WITH ADJUSTABLE CROSS-OVER FREQUENCY
If the amplifier is used as a subwoofer amplifier, set the switch (7) to "LPF”. Set the desired
cross-over frequency with the control (6). This makes the filter adaptable to the installed
woofer's sound requirements.
The filter's high edge steepness is responsible for the precision reduction of medium and
high frequency ranges.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Mac Audio mpx 2000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Mac Audio mpx 2000 in the language / languages: English, German, French as an attachment in your email.

The manual is 0,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info