522559

M-System MKK-770 Manual

4
Zoom out
Zoom in
Previous page
1/20
Next page
4
Istruzioni
per l’utente
Installazione
Tutte le operazioni relative
all’installazione
(allacciamento elettrico)
devono essere eseguite da
personale qualificato
secondo le norme vigenti.
Per le istruzioni specifiche
vedi la parte riservata
all’installatore.
Uso
Elementi riscaldanti -
comando manuale
(Figg. 1 - 2 - 2a - 3)
Ruotare la manopola sulla
posizione corrispondente
alle necessità di cottura
tenendo presente che a
numero maggiore corri-
sponde maggiore
erogazione di calore, vedi
tabella “utilizzo elementi
riscaldanti”.
Elementi a doppio
circuito
L’inserimento del secondo
circuito si ottiene ruotando a
fondo (11) la manopola (scat-
to e ritorno) e rimane inse-
rito per tutte le altre rego-
lazioni in discesa da 11 a 1.
Per il disinserimento
riportare la manopola in
posizione 0 (zero).
Le lampade spia accese
indicano:
A - inserimento di uno o
più elementi riscaldanti.
B - che nella zona
dell’elemento riscaldante
indicato la temperatura del
piano è superiore a 50
°
C.
Va comunque considera-
to normale, per certi tipi
di lampada, il permanere
di una leggera lumine-
scenza anche a comandi
disinseriti.
Instructions
pertaining to user
Installation
All operations relative to
installation (electric
connection) should be
carried out by skilled
personnel in conformity
with the rules in force.
As for the specific
instructions see part
pertaining to installer.
Use
Heating elements
manual control (Fig. 1 - 2
- 2a - 3)
Rotate the knob
concerned to the position
correspondant to the
needs of cooking taking
into conside-ration that to
a higher number a higher
heat supply corresponds,
see table “use of heating
elements”.
Double-circuit
elements
To activate the second
circuit press hard and
turn knob (11) (release
and return), the circuit
will be connected for all
positions decreasing
from 11 to 1. To
disconnect the circuit
turn back the knob to
position 0 (zero).
When pilot lights are lit,
they indicate.
A - one or more heating
elements are switched
on.
B -the top temperature at
the indicated spot is
higher than 50° C.
Some types of pilot
lights will maintain
some slight
luminescence even after
disconnection. That is
quite normal.
Instructions
pour l’utilisateur
Installation
Toutes les opérations relatives
à l’installation (raccordement
électrique) doivent être faites
par un personnel qualifié, en
conformité avec les normes en
vigueur.
En ce qui concerne les
instructions spécifiques
voir la partie réservée à
l’installateur.
Emploi
Eléments de chauffe -
commande manuelle (Fig. 1 - 2
- 2a - 3).
Amener le bouton de
commande dans la position
correspondante
à la puissance souhaitée ,
sachant qu’au numéro le plus
élevé correspond le maximum
de puissance (voir notre
tableau “utilisation des
élements de chauffe”).
Eléments a double
circuit
Le branchement du second
circuit a lieu en poussant à
fond et tournant le bouton
(11) (déclenchement et
retour); le circuit restera
actif pendant tout autre
réglage descendant de 11 à 1.
Pour le débrancher placez
le bouton à la position 0
(zero).
Les voyants lumineux
allumés indiquent.
A - le branchement d’un ou
plus éléments de chauffe
B - que la température au
point indiqué de l’élément
de chauffe est supérieure à
50
°
C.
Pour de certains types de
voyants lumineux la
permanence d’une légère
luminiscence même à
commandes déconnectées
est tout à fait normale.
IGBF
37
Arbeitstemperatur ver-
wendet werden. Das
Kabel darf an keiner
Stelle eine Temperatur
von mehr als 50°C über
der Raumtemperatur er-
reichen.
Falls ein direkter An-
schluß an das Stromnetz
gewünscht wird, ist es
notwendig einen all-
poligen Schalter mit
einer Mindestöffnung
von 3mm zwischen den
Kontakten, gemäß
Leistungsschild, zu legen
und den geltenden
Normen entsprechen.
(Das gelbgrüne Erdkabel
darf nicht vom Schalter
ausgeschaltet werden).
Die Steckdose oder der
allpolige Schalter
müssen bei dem instal-
lierten Apparat leicht zu
erreichen sein.
Der Hersteller lehnt jede
Verantwortung ab falls
oben genannte Ausführ-
ungen und die üblichen
Unfallnormen nicht ein-
gehalten werden.
directa a la red, es necesario
interponer un interruptor
omnipolar con abertura mí-
nima entre los contactos de
3 mm dimensionado para la
carga de placa y responder
a las normas vigentes (el
cable de tierra amarillo/
verde no tiene que ser
interrumpido por el int-
erruptor). El enchufe o el
interruptor omnipolar tie-
nen que ser fácilmente al-
canzables con el aparato
instalado.
El constructor declina
cualquier responsabilidad
en el caso de que lo dicho
arriba y las usuales normas
contra los infortunios no
sean respetadas.
ratuur, zoals aangegeven
op de registratieplaat. De
kabel mag op geen enkel
punt een temperatuur be-
reiken die hoger is dan
50°C boven de omge-
vingstemperatuur. Wenst
men een directe verbind-
ing met het lichtnet, dan is
het noodzakelijk een on-
derbrekingsschakelaar
tussen te plaatsen, met een
minimale afstand van 3
mm tussen de contacten,
die gedimensioneerd is
voor het geregistreerd ver-
mogen en voldoet aan de
geldende normen (de aar-
dekabel geel/groen mag
niet door de schakelaar
worden onderbroken). De
stekker of schakelaar moet
gemakkelijk bereikbaar
zijn als de apparatuur
eenmaal geinstalleerd is.
De fabrikant wijst iedere
verantwoordelijkheid af
in geval dat het boven-
staande en de gebruike-
lijke preventieve normen
niet worden gere-
specteerd.
recta à rede, será necessário
interpor um interruptor
onipolar com abertura
mínima de 3 mm. entre os
contactos, cuja dimensão
deverá seguir a carga men-
cionada na chapa, seguindo
igualmente as normas em
vigor ( o cabo de terra a-
marelo/verde não deve ser
interrompido pelo inter-
ruptor). A tomada ou o in-
terruptor onipolar deverão
ser posicionados para uma
fácil manipulação do apa-
relho instalado.
O construtor declina qual-
quer responsabilidade no
caso que não tenham sido
respeitadas todas as dispo-
sições aqui em cima, assim
como as normas para a
prevenção de acidentes.
DENLP
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for M-System MKK-770 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of M-System MKK-770 in the language / languages: English, German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info