522748

M-System EK-10 PLANA isola Manual

10
Zoom out
Zoom in
Previous page
1/28
Next page
10 EK 10
Italiano English Français
2.3 - FILTRI AL CARBONE ATTIVO
(solo versione filtrante)
- I filtri montati non sono rigenerabili
e quindi devono essere sostituiti
almeno ogni due mesi.
- Per la sostituzione è necessario:
Versione 1 (Fig.2A):
- Smontare i filtri antigrasso metal-
lici.
Versione 2 (Fig.2B):
- smontare i filtri antigrasso metal-
lici.
- rimuovere i due fermi metallici e
togliere il filtro e quindi rimontare il
nuovo filtro.
Versione 3 (Fig.2C):
- smontare i filtri antigrasso metallici
- ruotare il filtro di 90º ed estrarlo
- per il montaggio, il nuovo filtro
deve essere infilato nel nasello a
lato del motore e poi farlo ruotare
di 90º.
2.4 - ILLUMINAZIONE
- Per la eventuale sostituzione delle
due lampade montate bisogna:
- togliere i filtri antigrasso metallici e
spingere il ferretto all'esterno (Fig.3)
- estrarre la lampada e sostituirla con
una di uguali caratteristiche (40w
E14) poichè una di maggiore poten-
za potrebbe danneggiare seria-
mente l'impianto elettrico.
2.3 - ACTIVATED CARBON FILTERS
(Only filtering types)
- The filters cannot be regenerated
therefore they must be replaced at
least once every two months.
- Follow the replacing instructions
listed below:
Type 1 (Fig.2A):
- Disassemble the metal anti-grease
filters.
Type 2 (Fig.2B):
- Disassemble the metal anti-grease
filters.
- Remove the two metal locks and the
filter then assemble the new filter.
Type 3 (Fig.2C):
- Disassemble the metal anti-grease filters.
- Rotate the filter for approx. 90º and
remove it
- For assembly, slide the new filter in
the nib on the side of the motor and
then rotate it for approx. 90º.
2.4 - LIGHTING
- In order to replace the two lamps
follow the instructions below:
- remove the anti-grease metal filters
and push the little bar outwards
(Fig.3)
- replace the lamp with one that has
the same features (40w E14) be-
cause one with major power may
cause severe damage to the elec-
trical system.
2.3 - FILTRES AU CHARBON ACTIF
(seulement version filtrante)
- Les filtres montés ne peuvent être
régénérés et doivent donc être rem-
placés au moins tous les deux mois.
- Pour cela il faut:
Version 1 (Fig.2A):
- démonter les filtres anti-graisse
métalliques.
Version 2 (Fig.2B):
- démonter les filtres anti-graisse
métalliques.
- enlever les deux arrêts métalliques
ainsi que le filtre et remonter ensuite
le nouveau filtre.
Version 3 (Fig.2C):
- démonter les filtres anti-graisse
métalliques.
- tourner le filtre de 90º et l’extraire.
- pour le montage, on doit enfiler le
nouveau filtre dans le ergot
(mentonnet)sur le côté du moteur
et le faire ensuite pivoter de 90º.
2.4 - ILLUMINATION
Pour le remplacement éventuel
des deux lampes montées, il faut:
- Enlever les filtres métalliques anti-
graisse et pousser le petit fer à
l’extérieur (Fig.3).
- Remonter une ampoule avec les
mêmes caractéristiques (40w E14)
car une ampoule de plus grande
puissance pourrait gravement en-
dommager l’installation électrique.
Fig.2A
Fig.2C
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for M-System EK-10 PLANA isola at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of M-System EK-10 PLANA isola in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 29,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info