586985
10
Zoom out
Zoom in
Previous page
1/32
Next page
Page 8
2.2 Multi-Key Commands
In addition to the standard front panel controls detailed in 2.1, the Aurora has been programmed so that
extended functionality is available through the use of multi-key combinations, or by pressing a button
down while AC power is applied. The sections below detail these key combinations and the firmware
required for each to operate.
Power Up State
This command changes the power up state of the Aurora from STANDBY (the default) to ON. In
STANDBY mode, when AC power is applied, the POWER button must be pressed before the unit will
become operational. In ON mode, when AC power is applied the Aurora will be ready to use. ON is
the ideal setting when a single power switch is used to turn on an equipment rack.
To activate, hold the POWER button while connecting AC power. PLEASE NOTE: After the mode
is changed the unit must be put into standby mode to save this setting before power is removed again.
This function requires firmware revision 11 or higher in order to operate.
Restore Defaults
This command returns the Aurora to its factory default condition. SYNC SOURCE, ROUTING,
TRIM, AES states, etc. will all be impacted. This is a useful diagnostic step whenever performance
problems are encountered. To activate, press the SAMPLE RATE button while AC Power is applied.
This function requires firmware revision 11 or higher in order to operate.
Verify Firmware Revision
This command will display the current firmware version of the Aurora. In standby mode, press the
TRIM and POWER buttons simultaneously. The LEDs in the PEAK METER display will blink, and
the LED over one or two channels will flash repeatedly. This is the number of the active firmware
version. This function requires firmware revision 13 or higher in order to operate.
Dual Wire Select Mode
This command allows selection of the Dual Wire state for the Aurora’s AES digital channels. In this
Mode, when the METER button is set to “DIGITAL”, Dual Wire In and Dual Wire Out can be enabled
with the TRIM/AES MODE button. To activate, press the TRIM/AES MODE button while AC Power
is applied. To deactivate, turn the Aurora OFF and then back ON with the STANDBY button.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lynx Aurora 16 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lynx Aurora 16 in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info