599325
6
Zoom out
Zoom in
Previous page
1/93
Next page
2
IN-DASH MOUNTING
The LMS-350A can be installed in the dash with the supplied hardware if
the dash is 1/2" thick or less. Determining the dash thickness can be
difficult, however, if you remove a gauge from the dash, you can easilly
measure the thickness. Try this in an area that's close to the location that
you wish to install the unit, since the thickness can vary significantly in
some boats. Make certain there is clearance behind the dash for the unit
and there is enough room to tighten the bolts on both sides of the unit.
7.625"
5.375"
DASH CUTOUT
.400" radius
(4 places)
RUBBER PAD
BOLT
CAM CLAMP
(TURNED DOWN)
CAM CLAMP
(TURNED UP)
BOLT
Once you've determined the location for the unit, cut the hole according
to the drawing shown above. Measure carefully before cutting! After
cutting the dash, place the gasket supplied with the LMS-350A around the
unit and place the unit in the hole.
Supplied with the LMS-350A are rubber pads, bolts, washers, and cam
clamps to attach the LMS-350A to the dash. Peel the adhesive backing off
the rubber pads and place one on each side of the LMS-350A in the
location where the cam clamp will touch the back side of the dash. Using
the hardware supplied with the unit, attach the LMS-350A to the dash.
Make certain that the cam clamp on the left side of the unit is pointing down
and the cam clamp on the right side of the unit is pointing up before you
start tightening the bolts.
RUBBER PAD
LOWRANCE
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance LMS-350A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance LMS-350A in the language / languages: English as an attachment in your email.

The manual is 1,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info