23263
3
Zoom out
Zoom in
Previous page
1/12
Next page
3
Recommended Tools and Supplies
Supplies are not included, unless otherwise indicated. A transom mount
requires one #8 stainless steel screw (3/4" long) and a high quality, ma-
rine-grade above- or below-waterline sealant/adhesive compound. If you
want to make a pilot hole for the screw, use a drill and a 1/8" drill bit. If
you prefer the option of routing the temp sensor cable through the tran-
som (instead of over it), you will also need a 1/2" drill bit.
If the dash does not have a standard 2-1/8" (54 mm) hole, you will need a
drill or saw to make the hole. Carefully measure the dash thickness and
the hole area before cutting or drilling.
A screwdriver is needed for mounting the temp sensor. The buzzer in-
stallation requires two cable ties.
If you need to extend any of the wires, use a minimum of 24 gauge wire
and wire connectors of your choice. Wire nuts or electrical tape are re-
quired to cap any unused bare wires.
Mounting
The temperature sensor can be mounted in any convenient location.
However, make sure it is placed on the transom where it will be in con-
tact with the water at all times. Make sure the location does not interfere
with the boat's trailer.
Temp sensor on transom, with cable routed through the transom.
After determining the location, use the sensor as a template and mark
the hull for the screw's pilot hole, if desired. Route the sensor and cable
over or through the transom to the mounting location. If routing through
the transom, drill a 1/2" hole to accommodate the sensor. Attach the sen-
sor to the hull with one #8 stainless steel screw, then seal the screw with
the below-waterline sealant compound.
Caution:
If you drill a hole in the transom for the cable, make sure it is lo-
cated above the waterline. After installation, be sure to seal the ca-
ble hole with the same marine grade above-or below-waterline
sealant used for the screw.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance LDT3200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance LDT3200 in the language / languages: English as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info