23263
4
Zoom out
Zoom in
Previous page
1/12
Next page
4
When you determine the location for the LDT-3200, drill a 2-1/8" (54 mm)
hole in the dash or use an existing gauge hole. Slide the unit's cables
through the hole from the front side of the dash, then push the LDT-3200
housing through the hole until it is flush with the dash surface. Make
sure the gauge is aligned correctly. Next, slide the rubber gasket and
plastic mounting collar over the cables and onto the back side of the
gauge.
Insert gauge through the hole in the front side of the dash (left). Slide
the rubber gasket over the cables, followed by the plastic collar (right).
Slide the gasket forward so it is flush with the back of the dash, then
screw on the mounting collar, turning it until it is snug against the gas-
ket and the back of the dash.
Find a buzzer location that is protected from the elements, but still lets
you hear it. We recommend that you connect the buzzer wires, then use
two cable ties and attach the buzzer to one or both of the cables at the
back of the gauge. (Some dashboards are too thin to screw into.)
Finish the installation by connecting the cables as described in the fol-
lowing wiring diagrams and photos.
Wiring
The LDT-3200 operates from 10 to 15 volts DC (12-volt system). It must
be wired to a 1-amp fuse. Failure to use a fuse with this product will void
the warranty and could result in damage to the unit or your boat.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance LDT3200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance LDT3200 in the language / languages: English as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info