599173
39
Zoom out
Zoom in
Previous page
1/66
Next page
| 37
Software setup | HDS Gen3 Installation Manual
Radar setup
Setup and use of the Broadband
radar has been simpli ed when
compared to traditional pulse
radars. There is no zero range
(time delay), no warm up time,
and no burn-in required.
Radar status
Displays scanner information, the
availability and status of scanner
features, and the status of radar peripherals.
Reset Device ID
HDS displays only support one radar on the network. Should a radar
be connected, that has been previously connected to a dual radar
network in the past, it may not be detected by the display because
it has an incorrect Device ID. To resolve this problem select Reset
device ID on the Radar status page, and follow the on screen
prompts.
Adjust bearing alignment
This is to align with the heading marker on the screen with the
center line of the vessel, compensating for any slight misalignment
of the scanner during installation. Any inaccuracy will be evident
when using MARPA or chart overlay.
Point the boat to be perpendicular to the very end of a breakwater
or peninsula. Adjust the bearing alignment setting, so that the
heading marker and land mass intersect.
Adjust antenna height
Set the radar scanner height above water. The Radar uses this value
to optimize removal of sea clutter (radar re ections from waves)
from the display.
Adjust local interference reject
Interference from some onboard sources can interfere with the
Broadband radar. One symptom of this could be a large target on
the screen that remains in the same relative bearing even if the
vessel changes direction. Choose from Local interference rejection
LOW, MED or HIGH. Default is LOW.
d
e
e
r
39


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS Gen3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS Gen3 in the language / languages: English as an attachment in your email.

The manual is 7,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS Gen3

Lowrance HDS Gen3 User Manual - English - 184 pages

Lowrance HDS Gen3 Quick start guide - German - 8 pages

Lowrance HDS Gen3 User Manual - German - 176 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info