470141
13
Zoom out
Zoom in
Previous page
1/28
Next page
13
Sand both the inside surface of the hull,
where the transducer is to be epoxied,
and the face of the transducer.
You may want to start with a rougher
grit sandpaper, such as 60 grit, and n-
ish with a smoother grit, such as 160 grit,
sandpaper. Sand the inside surface of the
hull until it is smooth to the touch.
The sanded area should be about 1-1/2
times the diameter of the transducer. Af-
ter sanding, clean the hull and face of the
transducer with an alcohol wipe to re-
move any sandpaper grit and dust.
Apply a thin layer of epoxy (about 1-16"
or 1.5 mm) on the face of the transducer
and the sanded area on the hull. Make
sure there are no air pockets in the ep-
oxy layers.
Press the transducer into the epoxy, twist-
ing and turning it to force any air bubbles
out from under the transducer face. Stop
pressing when it bottoms out on the hull.
Apply pressure to hold the transducer in
place while the epoxy sets. Be careful not
to move the transducer while the epoxy
is setting. Allow the epoxy to set before
moving the boat.
When nished, the face of the transducer
should be parallel with the hull with a
minimum amount of epoxy between the
hull and transducer.
After the epoxy has set, route the
transducer cable to the sonar unit.
1. Sand face
of transducer
and bottom of
hull.
2. Apply ep-
oxy to face
of transducer
and bottom of
hull.
3. Epoxy transducer to hull.
Hull
Epoxy
On vee hulls try to place the transducer
where the deadrise is 10° or less.
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lowrance HDS-5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lowrance HDS-5 in the language / languages: English as an attachment in your email.

The manual is 5,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Lowrance HDS-5

Lowrance HDS-5 Quick start guide - English - 6 pages

Lowrance HDS-5 User Manual - English - 129 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info