602190
25
Zoom out
Zoom in
Previous page
1/80
Next page
18
Chapter 5: Configuring the ADSL Gateway
The Setup Tab
ADSL Gateway with 4-Port Switch
Optional Settings (Required by some ISPs)
Host Name and Domain Name. These fields allow you to supply a host and domain name for the Gateway.
Some ISPs require these names as identification. You may have to check with your ISP to see if your
broadband Internet service has been configured with a host and domain name. In most cases, leaving these
fields blank will work.
MTU. The MTU (Maximum Transmission Unit) setting specifies the largest packet size permitted for network
transmission. Select Manual and enter the value desired. You should leave this value in the 1200 to 1500
range. By default, MTU is configured automatically.
Network Setup
Router IP. The values for the Gateway’s Local IP Address and Subnet Mask are shown here. In most cases,
keeping the default values will work.
Local IP Address. The default value is 192.168.1.1.
Subnet Mask. The default value is 255.255.255.0.
Network Address Server Settings (DHCP). A Dynamic Host Configuration Protocol (DHCP) server automatically
assigns an IP address to each computer on your network for you. Unless you already have one, it is highly
recommended that you leave the Gateway enabled as a DHCP server.
Local DHCP Server. DHCP is already enabled by factory default. If you already have a DHCP server on your
network, set the Gateway’s DHCP option to Disable. Only use DHCP Relay if requested by your ISP; your
ISP will supply you with the IP Address
DHCP Server. If you enable the DHCP Server or DHCP Relay for the Local DHCP server, enter the IP address
for the DHCP server in the fields.
Starting IP Address. Enter a value for the DHCP server to start with when issuing IP addresses. This value
must be 192.168.1. 2 or greater, because the default IP address for the Gateway is 192.168.1.1.
Number of Address. Enter the maximum number of computers that you want the DHCP server to assign IP
addresses to. This number cannot be greater than 253. By defaul, the range is 192.168.1.100 to
192.168.1.149.
DHCP Address Range. The range of DHCP addresses is displayed here.
Client Lease Time. Enter the minutes in the field.
Figure 5-9: Setup Tab - Optional Settings
domain: a specific name for a network of computers
packet: a unit of data sent over a network
subnet mask: an address code that
determines the size of the network
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Linksys AG041 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Linksys AG041 in the language / languages: English as an attachment in your email.

The manual is 1,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info