600889
14
Zoom out
Zoom in
Previous page
1/36
Next page
14
OPTION C: Floor Installation
1. Use wood blocks or extension brackets (see Accessories) to elevate sensor brackets
so the lenses will be no higher than 6" (15 cm) above the fl oor.
2. Carefully measure and place right and left assemblies at the same distance out from
the wall. Be sure all door hardware obstructions are cleared.
3. Fasten to the fl oor with concrete anchors as shown.
Installation
Fasten Wood Block to Wall with
Lag Screws (not provided)
Attach with
Concrete Anchors
(not provided)
OPTION A: Track Installation
1. Slip the curved arms over the rounded edge of each door track, with the curved arms
facing the door. Snap into place against the side of the track. It should lie fl ush, with
the lip hugging the back edge of the track, as shown.
If your door track will not support the bracket securely, wall installation is recommended.
OPTION B: Wall Installation
1. Place the bracket against the wall with curved arms facing the door. Be sure there is
enough clearance for the sensor beam to be unobstructed.
2. If additional depth is needed, an extension bracket (see Accessories) or wood blocks
can be used.
3. Use bracket mounting holes as a template to locate and drill (2) 3/16" diameter pilot
holes on the wall at each side of the door, no higher than 6" (15 cm) above the fl oor.
4. Attach brackets to wall with lag screws (not provided).
If using extension brackets or wood blocks, adjust right and left assemblies to the same
distance out from the mounting surface. Make sure all door hardware obstructions are
cleared.
INSTALLING THE BRACKETS
Be sure power to the opener is disconnected. Install and align the brackets so the safety reversing sensors will face each other across
the garage door, with the beam no higher than 6" (15 cm) above the fl oor. Choose one of the following installations.
Door Track
Safety Reversing
Sensor Bracket
Safety Reversing
Sensor Bracket
Lag Screws
(not provided)
Safety Reversing
Sensor Bracket
(Provided with
Extension Bracket)
Extension Bracket
(See Accessories)
Safety Reversing
Sensor Bracket
(Provided with
Extension Bracket)
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liftmaster 8500 Elite at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liftmaster 8500 Elite in the language / languages: English as an attachment in your email.

The manual is 5,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info