669736
8
Zoom out
Zoom in
Previous page
1/21
Next page
16
17
DT-7 Desk: Assembly Instructions
Step 1: Lift Frame Assembly
A. Position the lift frame (1),
left base foot (3) and right
base foot (4) as shown in the
figure to the right. Note the
position of the Workplace
logo as well as the right and
left base feet.
B. Place the lift frame onto
the left and right base feet
mounting bolts and install
the M10 washer (11) and
M10 acorn nut (6).
C. Tighten the four mounting
nuts.
Step 2: Accessory Tray Assembly
A. Remove the four screws
(9) pre-installed in the
bottom of the upright
assembly crossbar.
B. Line the holes in the
accessory tray (10)
with the holes in the
crossbar.
C. Install four M8 washers
and M8*15 bolts (9) and
tighten.
9
10
Step 3: Desktop Assembly
NOTE: It is a good idea to use two people for this portion of the
assembly in order to be sure wires are properly routed and do not get
pinched while installing the desktop.
A. Remove the bolts (7),
washers (5), and nuts
(8) pre-installed in the
upright assembly posts.
B. Hold the desktop (2)
over the lift frame (1)
and place the desk
height control wire
harness (15) and the
console wire harness
(14) into the center of
the lift frame (1). Place
the connector ends
towards the center of
the tray for easy access
in the next steps of the
assembly.
C. Set the desktop down
into the mounting brackets (C) on the extension tubes, align the
mounting holes and re-install the hardware removed in step A.
D. Tighten the desktop mounting bolts/nuts.
DT-7 Desk: Assembly Instructions
2
14
15
C
C
1
3
4
Workplace
Logo
A
Desk positioning
bumpers facing inward
6
5
1
8
5
7
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lifespan C3-DT5 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lifespan C3-DT5 in the language / languages: English as an attachment in your email.

The manual is 3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info