716906
7
Zoom out
Zoom in
Previous page
1/32
Next page
WARNING
Leaking coolant and oil!
Fire. The coolant contained in the appliance is eco-friendly,
but also flammable. The oil contained in the appliance
is flammable. Escaping coolant and oil can ignite if the
concentration is high enough and in contact with an
external heat source.
uDo not damage the pipelines of the coolant circuit and
the compressor.
WARNING
Fire hazard and danger of damage!
uDo not place appliances emitting heat e.g. microwaves,
toasters etc. on the appliance!
NOTICE
Covered vents!
Damage. Appliance can overheat, which can reduce the
service life of various parts of the appliance and lead to
operational impairments.
uAlways make sure there is good ventilation.
uAlways keep vents or ventilation grids in the appliance
housing and in the kitchen furniture (fully integrated
appliance) unobstructed.
uAlways keep the fan air vents unobstructed.
If your appliance is not a side-by-side (SBS) appliance:*
NOTICE
Risk of damage due to condensate!*
uDo not install the appliance directly alongside a further
refrigerator/freezer.
Note
If you have several appliances next to one another, leave a
gap of 70mm between appliances. Otherwise condensation
will build up between the units.*
Fig. 8 *
qBefore you connect the appliance, report any damage
immediately to the delivery company.
qThe floor of the installation site must be horizontal and
even.
qDo not install the appliance in direct sunlight, next to an
oven, radiator or similar.
qInstall the appliance with the rear panel up against the
wall and always use the supplied wall spacers (see
below).
qOnly ever move the appliance when it is empty.
qThe surface supporting the appliance must be at the
same level as the surrounding floor.
qDo not install the appliance on your own.
qThe more coolant there is in the appliance, the larger
the room in which the appliance is installed must be. If
the room is too small, any leak may create a flammable
mixture of gas and air. For each 8 g of coolant the instal‐
lation space must be at least 1 m3. Information on the
coolant is on the model plate inside the appliance.
uRemove the protective film from the outside of the appli‐
ance.
NOTICE
Risk of damage from stainless steel care products!
The stainless steel doors and stainless steel side panels
are treated with a premium surface finish.
Stainless steel care products attack these surfaces.
uOnly use a soft, clean cloth to wipe down finished door
and side panel surfaces and painted door and side panel
surfaces. To remove heavy dirt, use a little water or
neutral detergent. Alternatively, you can use a micro-fibre
cloth.
uRemove all transit supports.
Spacers must be used to achieve the declared energy
consumption and to prevent condensation in the event of
high surrounding humidity. This increases the appliance
depth by about 15 mm. The appliance will work perfectly
well without the spacers but will have a slightly higher
energy consumption.
uIf your appliance comes with
wall spacers, mount these on
the back of the appliance,
bottom left and right.
uDispose of packaging material (see 4.6 Disposing of
packaging) .
CAUTION
Risk of injury or damage from the appliance tipping or the
door falling open!
If the additional adjustable foot on the base support is not
correctly positioned on the floor, there is a risk of the door
falling open or the appliance tipping. This can lead to injury
or property damage.
uUnscrew the additional adjustable foot on the support
until it reaches the floor.
uThen turn it another 90°.
uAlign the appliance so that it
stands firmly and on a level
by applying the accompa‐
nying spanner to the adjust
able-height feet (A) and
using a spirit level.
uThen support the door:
Extend the adjustable foot
at the turn hinge (B) until it
rests on the floor and then
make a further 90° turn.
When a Side-by-Side appliance (S) is fitted together
with a second appliance (as a SBS combination):*
uProceed according to the Side-by-Side combined fridge-
freezer installation instructions. (Accessories bag of the
SBS freezer/appliance with freezer compartment)*
Note
uClean the appliance (see 6.4 Cleaning the appliance) .
Putting into operation
* Depending on model and options 7
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr SWTNes 4285 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr SWTNes 4285 in the language / languages: English as an attachment in your email.

The manual is 2.28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr SWTNes 4285

Liebherr SWTNes 4285 User Manual - German - 34 pages

Liebherr SWTNes 4285 User Manual - Dutch - 34 pages

Liebherr SWTNes 4285 User Manual - French - 34 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info