804852

Liebherr RBstd 528i Manual

7
Zoom out
Zoom in
Previous page
1/14
Next page
Fig. 8
uInsert the spacer
Fig. 8 (13)
back under the right-hand side
of the door, as it is important for the stability of the appliance.
WARNING
Risk of injury due to the door dropping out!
If the bearing parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What is
more, the door may not close and therefore the appliance may
fail to cool properly.
uScrew on the bearing brackets/bearing pins tightly (4 Nm).
uCheck all of the screws and retighten if necessary.
4.4 Undercounter installation
WARNING
Fire hazard from short-circuiting!
uWhen pushing the appliance into the recess, take care not to
crush, jam or damage the mains power cable.
uDo not operate the appliance with a defective mains power
cable.
Counter height appliances up to 850 mm in height can be
installed below the worktop. In the case of continuous work-
tops, the cover on the refrigerator can be removed and the
appliance slid in under the worktop.
With such installations, the plug
Fig. 9 (1)
must not be located
behind the appliance and must be easily accessible.
For the purpose of ventilation and aeration at the rear of the
appliance, a min.140 cm2 ventilation cavity is required. With an
installation depth of 600 mm, the wall connection profile on the
worktop must not exceed a max. 10 mmin depth.
Fig. 9
In order to take off the appliance cover:
uRemove the screws
Fig. 9 (2)
from the rear side.
uRaise the cover up at the back, slide forward and lift up and
off the appliance.
4.5 Sliding into the row of units
Fig. 10
(1) Top cupboard* (3) Kitchen cabinet*
(2) Appliance* (4) Wall*
x For appliances with supplied wall spacers, add 35 mm
(see 4.2 Installing the appliance) to the dimensions.
The appliance can be built into kitchen units. A top cupboard
Fig. 10 (2)
can be added above the appliance in order to bring
the appliance
Fig. 10 (1)
up to the height of the fitted kitchen
units.
If you are integrating the appliance into a kitchen unit (max.
depth 580 mm) you can install it right next to the kitchen
cabinet
Fig. 10 (3)
. The appliance measures 34 mm x at the
side and 50 mm x at the centre in relation to the front of the
kitchen cabinet.*
NOTICE
Danger of overheating due to insufficient air ventilation!
The compressor may be damaged if there is insufficient air
ventilation.
uTake care to ensure adequate air ventilation.
uObserve the ventilation requirements.
Ventilation requirements:
-At the back of the top cabinet, there must be an air outlet
shaft at least 50 mm deep spanning the entire width.
-The ventilation above must be at least 300 cm2.*
-The wider the ventilation clearance, the more efficiently the
appliance will run.
If you are installing the appliance with the hinges next to a wall
Fig. 10 (4)
, the distance between the appliance and the wall
must be at least 40 mm. This is how far the handle protrudes
when the door is open.*
4.6 Disposing of packaging
WARNING
Danger of suffocation due to packing material and plastic film!
uDo not allow children to play with packing material.
The packaging is made of recyclable materials:
-corrugated board/cardboard
-expanded polystyrene parts
-polythene bags and sheets
-polypropylene straps
-nailed wooden frame with polyethylene panel*
uTake the packaging material to an official collecting point.
Putting into operation
* Depending on model and options 7
… 7 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr RBstd 528i at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr RBstd 528i in the language / languages: English as an attachment in your email.

The manual is 6.33 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Liebherr RBstd 528i

Liebherr RBstd 528i User Manual - German - 30 pages

Liebherr RBstd 528i User Manual - Dutch - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info