726273

Liebherr BCv 1103 Manual

10
Zoom out
Zoom in
Previous page
1/40
Next page
10
Setting up
• Do not place the appliance in direct sunlight or near
cookers, radiators and similar sources of heat.
• The oor on which the appliance stands
should be horizontal and level.Compen-
sate for uneven oors with the adjust-
able feet.
• ATTENTION: There must be a gap of at least 10 cm
between the side enclosure (left and right) and rear
enclosure of the appliance against the wall.
• Always ensure there is good ventilation and that the
outward owing air is able to escape. Always install the
appliance directly against the wall.
• Do not cover ventilation openings or grille.
• Standard EN 378 species that the room in which you
install your appliance must have a volume of 1 m
3
per
8 g of R 600a / R 290 refrigerant used in the appli-
ance, so as to avoid the formation of inammable gas/air
mixtures in the room where the appliance is located in
the event of a leak in the refrigerant circuit. The quantity
of refrigerant used in your appliance is indicated on the
type plate on the inside of the appliance.
Electrical connection
Only operate the appliance with alternating current (AC).
The permissible voltage and frequency are indicated on
the type plate. The position of the type plate is shown in
the section entitled Description of the appliance.
The socket must be properly earthed and protected by a
fuse.
The tripping current of the fuse must be between 10 A and
16 A.
The socket must not be situated behind the
appliance and must be easily accessible.
Do not connect the appliance using an exten-
sion cable or extension socket.
Do not use stand-alone inverters (conver-
sion of direct current to alternating current / three phase
current) or energy-saving plugs. Risk of damage to the
electronic control system!
Switch the appliance on and o
You are recommended to clean the appliance before
switching it on for the rst time. The appliance is delivered
ready for use and wired for normal operation. When it is
connected up, the appliance is ready for operation.
To switch the appliance on
Connect the appliance to the mains - the appliance is
switched on.
To switch the appliance o
Pull out the mains plug - the appliance is switched o.
Important
When the temperature control is turned to “•“, the refrig-
eration system is switched o, but the appliance is not
completely disconnected from the mains.
Temperature display
The thermometer is located on the left of
inner compartment.
T
Setting the temperature
Using a coin, turn the arrow of the
temperature control T to a setting
between 1 and 7.
Setting 1 = highest temperature
Setting 7 = lowest temperature
Climate rating
The climate rating indicates the room temperature at which
the appliance maybe operated in order to achieve full refrig-
eration performance.
The climate rating is indicated on the type
plate.
The position of the type plate is shown
in the section entitled Description of the
appliance.
Climate rating Room temperature
0 20°C
3 25°C
4 30°C
7 35°C
Do not operate the appliance outside the
specied room temperature range.
GB
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Liebherr BCv 1103 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Liebherr BCv 1103 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info