694810

Lenco KCR-100 Manual

10
Zoom out
Zoom in
Previous page
1/57
Next page
10
Recall Stored FM Presets
Press the MEMORY button on the unit (or the CH-/CH+ button on the remote control) to tune to different preset channel.
To directly recall the preset channel by using the numeric buttons on the unit, press the numeric buttons [1], [2], …, [5].
For example when the button [3] is pressed, the display shows “P03” and wait for a while it will tune to the preset 3.
Or when press and hold the button [3/(8)] button until the display shows “P08” and wait for a while, it will tune to the preset 8.
Or when press the button [1] button and followed by pressing the button [2], the display will show “P12” and after a while it will tune
to the preset 12.
Or when press the button [1] button and followed by press and hold the button [3/(8)], the display will show “P18” and after a while
it will tune to the preset 18.
Alternatively you can use the remote control numeric buttons to directly recall the preset channel, press the numeric buttons [1],
[2], …, [9], [0].
For example when the button [3] is pressed, the display shows “P03” and wait for a while it will tune to the preset 3.
Or when press the button [8] until the display shows “P08” and wait for a while, it will tune to the preset 8.
Or when press the button [1] and followed by pressing the button [2], the display will show “P12” and after a while it will tune to the
preset 12.
Or when press the button [1] and followed by press the button [8], the display will show “P18” and after a while it will tune to the
preset 18.
Stereo/Force Mono Selection
When receiving a Stereo FM radio channel, press the ST/MONO button will switch between stereo audio and force mono audio.
When it is in FM Stereo, the FM-ST LED will be turned on.
Note:
- The antenna wire at the rear panel of the unit should be fully extended to ensure a good FM reception. Alter the antenna
position for the best reception.
BLUETOOTH AUDIO
Please follow the pairing instructions below to link the unit to your Bluetooth device.
1. Press the SOURCE button to enter the Bluetooth mode. The display will show “bLUE”. It will start searching and the BT LED will
flash.
2. If the unit has never been paired with a Bluetooth device before or cannot find the last paired device, the BT LED will keep on
flashing. Turn on the Bluetooth function of your device and enable the search until “Lenco KCR-100” is found. Select “Lenco KCR-
100” on the Bluetooth device to make connection. Enter the pass code “0000” if required.
3. After successfully paired the BT LED will become steady without flashing.
4. You can now start playing music from your smartphone wirelessly to the speaker.
5. You can press the PLAY/PAUSE button to pause or resume the playback.
6. You can press the PREVIOUS or button to skip to the previous or next song.
• Press and hold the PAIRING button will disconnect the current connection and start to search another new Bluetooth device.
SLEEP FUNCTION
1. When the unit is switched on, press the SLEEP button on the remote control repeatedly to select the sleep duration in minutes
from 05, 10, 15, 30, 45, 90 and 00 (sleep off).
2. When the sleep timer is zero, the unit will be turned off automatically.
3. To cancel the sleep function, press and hold the STANDBY button on the unit (or press the STANDBY button on the remote
control) to turn off. Alternatively press the SLEEP button repeatedly to “00”.
CLOCK SETUP
1. Turn off the unit in Standby mode.
2. Press and hold the CLOCK SET button on the unit (or press the CLOCK SET button on the remote control) to enter the Clock setup.
“24H” or “12H” will be displayed.
3. Press the MIN. and SEC button on the unit (the MIN. and SEC. button on the remote control) to toggle between 24H (display 24
hours format) or 12H (display 12 hours format). Press the CLOCK SET button on the unit (the CLOCK SET button on the remote
control) to confirm.
4. Press the MIN. and SEC button on the unit (the MIN. and SEC. button on the remote control) to adjust the hour and minute
respectively. Press the CLOCK SET button on the unit (the CLOCK SET button on the remote control) to finish the clock set.
… 10 …


Need help? Post your question in this forum.

Forumrules
1

Forum

lenco-kcr-100

Reset search

  • Finns det bruksanvisning på lenco Modell KCR-100 på svenska
    Submitted on 6-8-2020 at 11:07

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lenco KCR-100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lenco KCR-100 in the language / languages: English, German, Dutch, French, Spanish as an attachment in your email.

The manual is 2,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info