21
While a FM station is playing, the screen shows one of the two following sets data:
⚫ If RDS information is available, by default the service name (i.e. station name) is
displayed. You can cycle through further RDS information by pressing Info. Each time
you press Info, another set of information is displayed, cycling through RDS radio text,
RDS programme type, frequency and today’s date.
⚫ If no RDS information is available, the currently tuned frequency is shown.
Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor signal-to-noise
ratio (hiss) from weak stations. To change the scan setting to stop only at stations with good
signal strength, select Menu > Scan setting > Strong stations only? > Yes
Audio Settings
By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a
poor signal-to-noise ratio (hiss). To play weak stations in mono, select Menu > Audio setting >
FM weak reception: Listen in mono only > Yes.
Station Recall:
After preset completed, press the MEMORY button or the Preset button to recall the stored
station, press the OK knob or the OK button to listen to the selected station.
When Scan is selected, the unit will scan and stop at the next available station.
When Manual tune is selected, there will be a list of certain frequency, select one and play.
When Prune invalid is selected, there will remove all invalid stations from list.
Select "YES" to remove all invalid stations, select "NO" to cancel.
When DRC is selected, set it to DRC high, DRC low or DRC off.
There are 3 levels of compression:
DRC Off - no compression. This is the default setting.
DRC Low - medium compression.
DRC High - maximum compression.
When Station order is selected, set it to Alphanumeric, Ensemble or Valid.
