792969

Lenco DAR-045 Manual

9
Zoom out
Zoom in
Previous page
1/97
Next page
9
To replace a new battery, please refer to the figure shown below. When inserting a battery, be sure to do so in the proper direction.
● If the remote control conflicts with other devices, the operation will be affected.
● Do not simultaneously press buttons on the unit and the remote control.
● Avoid using two remote controls at the same time as it will cause a malfunction.
● Use only CR-2025 size batteries.
● If there is battery leakage, clean the remote control thoroughly before replacing batteries.
● Do not short two terminals of the batteries. Dispose old batteries in a suitable place.
BASIC OPERATION
Plug the AC/DC power adaptor into a AC mains outlet and the other end of the cable into the DC IN 9V jack at the back of the unit.
The display will show “SCANTIME”. The unit is now updating the time from the broadcaster. Wait for a while until it is finished and the
real time will be display.
Press the STANDBY button to turn on the unit. To turn off, press the STANDBY button again.
DAB+/FM/CD/AUX/Bluetooth
Press the SOURCE button to choose the different sources.
Volume Control
Press the VOLUME +/- buttons on the unit or the VOL-/+ buttons on the remote control to change the volume.
Adjusting the Antenna
The antenna wire at the rear panel of the unit should be extended to ensure a good DAB+/FM reception. Alter the antenna position
for the best reception.
DAB+ OPERATION
The first time the DAB+ mode is selected, it will automatically scan for available DAB+ stations. Wait until the scanning has finished.
The display will show the scanning progress. After scanning it will tune to the first station.
Auto Scan
1. Turn on the unit in DAB+ mode.
2. Press the SCAN button to start auto-scanning the available stations.
CR2025 battery
Battery case
Pull out the battery case
Push in according to this direction
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lenco DAR-045 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lenco DAR-045 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 1.96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info