495524
15
Zoom out
Zoom in
Previous page
1/21
Next page
Installation of the machine - Service Provider Manual
ENGLISH
Display Meaning Action
The coffee grounds drawer has
been removed following a warning
from the machine.
Empty the coffee grounds drawer. Do not insert the
drawer while this message shows.
The machine has interrupted the
brewing cycle.
An alarm signal has been triggered, terminating
the brewing cycle. If necessary, contact the service
provider.
The machine is in energy saving
mode.
Press any button or open the capsule loading tray to
activate the machine.
The machine is priming the water
circuit.
Wait for this step to be successfully completed by the
machine.
The descaling lter must be
replaced.
Request assistance from the service provider.
Appears automatically when
programming the brew unit
washing every 24 hours.
Via the keypad start or disable the rinse cycle (see
section 4.5)
Only for machines with Water
Network.
The water supply network has
been cut off.
Request assistance from the service provider.
Only for machines with Water
Network.
The machine is able to function
using the tank positioned at the
rear.
Request assistance from the service provider.
Fill the tank as described in section 4.1 and use the
machine. Press button (15).
Problems Causes Solutions
The machine does
not switch on.
The machine is not connec-
ted to the electric network
Contact the Service Provider.
The main power button has
not been pressed
Turn on the machine via the main power button.
The machine does
not work
No message on the display Contact the Service Provider
If Out of Service message
11 appears on the display
Check if the previously inserted capsule is in the capsule
loading tray. If so, replace the capsule with another one,
then turn the machine off and back on again. If the problem
persists, contact the Service provider.
If Out of Service message
2x (e.g. 21) appears on the
display
Check that the water tank is full and correctly inserted into
its seat, then turn the machine off and back on again. If the
problem persists, contact the Service provider.
If Out of Service message
3x, 5x, 6x, 7x (e.g. 55) ap-
pears on the display
Contact the service provider.
If Out of Service message
8x or 9x appears on the
display
Turn the appliance off and back on again once only. If the
problem persists, contact the service provider.
Lavazza
Emptying
cof.groun.drawer
Wait please…
Lavazza
Brewing
interrupted
Wait please…
Lavazza
Stand-By
Press a key
to start
Lavazza
Loading
Water
Wait please…
Lavazza
Ready
Filter replac.
Lavazza
Water network
interrupted
Lavazza
Empty and fill
water tank
Press Enter
Lavazza
Rinsing
C to terminate
Enter to confirm
9 HANDLING AND STORAGE
All the operations described in chapter 9
must be performed exclusively by the ser-
vice provider or specialised technician,
who shall organise all operating sequences and
employ suitable means to ensure strict compliance
with safety regulations in force.
9.1 Handling
During handling and transportation, the machine should
be kept in a vertical position, in accordance with the
instructions printed on the packaging.
Care should be taken during lifting and positioning.
Do not shake the machine.
During lifting and handling of the load, en-
sure that the surrounding area is free of
people, and in dif cult conditions assign suitable
personnel to monitor all movements.
9.2 Storage
The machine should be stored in accordance with the
following conditions:
- minimum temperature: above 4°C.
- maximum temperature: below 40°C.
- maximum humidity: below 95%
The machine is packed in cardboard and expanded
polystyrene packaging.
Warning. Due to the total weight of the
packaged product, machines may not be
stacked higher than three units. The machine
should be stored in its original packaging, in a
place free from humidity and dust.
10 INSTALLATION
All the operations described in chapter
10 must be performed exclusively by the
service provider or specialised techni-
cian, who shall organise all operating sequences
and employ suitable means to ensure strict com-
pliance with safety regulations in force.
10.1 Safety regulations
Read the entire instruction manual carefully.
Connection to the power supply should be made in
compliance with the safety regulations in force in
the country where the machine is to be used.
Connection to the drinking water network (for water
network machines) should be made in compliance
with the safety regulations in force in the country
where the machine is to be used.
The socket to which the machine is connected must
be:
- compatible with the type of plug installed on the
machine;
- suitably sized to comply with the data on the pla-
te attached to the bottom of the appliance.
- connected to an ef cient earthing system.
The power cord must not:
- come into contact with any type of liquid: danger
of electric shocks and/or re;
- be crushed and/or come into contact with sharp
surfaces;
- be used to move the machine;
15
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Lavazza LB2300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Lavazza LB2300 in the language / languages: English as an attachment in your email.

The manual is 2,76 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info