646792

Laserliner Revolution Manual

27
Zoom out
Zoom in
Previous page
1/116
Next page
27
Revolution / Revolution Green
Horizontal and vertical use
Setting up
• Horizontal: Position the device on a level surface or on a tripod.
• Vertical: unfold centric point (J) and position unit in vertical mode. Pre-
adjust unit with vertical vial (O) and adjusting screws (N). The sensor then
adjusts the unit automatically. The device can be mounted on a construc-
tion tripod by means of the 5/8" thread (K).
• A plumb can easily be raised with the reference/plumb beam.
Tip: When installing dividing walls align the reference beam parallel to
the wall (please refer to picture B on page 2).
• PRESS THE "ON/OFF" SWITCH
• The device levels itself automatically to within a range of ± 4°. During the set-up
phase, the laser flashes and the prism head remains stationary. The operation/battery
indicator is lit up continuously. When levelling is complete, the laser lights up conti-
nuously and rotates at maximum speed.
Anti-shake function
This function enables you to use the device when it is still in the
set-up phase. The laser will continue to rotate whilst it is being
aligned by the automatic sensor. This makes device set-up easier,
as it enables the laser to be set to a required height by means of a
crank tripod or a wall bracket, for example. It also means that the
laser can be used on vibrating surfaces and in windy conditions.
This function can be used in combination with the single slope
function and all laser modes except adjustment mode, and for both
horizontal and vertical operation. The function is activated via the
anti-shake button: when it is pressed, the anti-shake LED lights up.
IMPORTANT: Precision is adversely affected during the set-up phase.
L
Attention: If the device has been placed on a surface with too much of a slope (more
than 4°), there is a warning sound, the prism head remains stationary and the laser
starts to flash. The device must then be placed on a more even surface.
L
Note: If the vertical vial is precisely aligned, the laser is lined up exactly with the
centric point.
GB
… 27 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner Revolution at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner Revolution in the language / languages: English, German, Dutch, French, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 2,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info