646716
33
Zoom out
Zoom in
Previous page
1/68
Next page
Cubus / Cubus G
33
A1
A2
2.
1.
A1
A3
A2
A2
A1
4.
3.
A3
A2
<
1,5 mm / 10 m = OK
Wanneer bij de X- of Z-as het verschil tussen punt A2 en A3 groter
is dan aangegeven als tolerantie nl. 1,5 mm / 10 m, is een afstelling
nodig. Neem hiervoor contact op met uw vakhandelaar.
!
Kalibratie controleren
3. Plaats het toestel zo dicht mogelijk tegen de wand ter hoogte van punt A1.
Richt het toestel uit op de X-as.
4. Draai het toestel vervolgens 180° en markeer punt A3. Het verschil tussen
A2 en A3 moet binnen de tolerantie van de nauwkeurigheid zitten.
5. Herhaal punt 3 en 4 voor de Y- en Z-as voor volledige controle.
Kalibratie controle voorbereiden
U kan de kalibrering van de laser controleren. Plaats het toestel in het
midden tussen twee muren die minstens 5 meter van mekaar verwijderd zijn.
Schakel het toestel aan. Voor een optimale controle een statief gebruiken.
BELANGRIJK: de Sensor-Automatic moet actief zijn (auto/slope-LED is uit).
1. Markeer punt A1 op de wand.
2. Draai het toestel 180° om en markeer het punt A2. Tussen A1 en A2
heeft u nu een horizontale referentie.
NL
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner Cubus G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner Cubus G in the language / languages: English, German, Dutch, Danish, French, Spanish as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info