646716

Laserliner Cubus G Manual

66
Zoom out
Zoom in
Previous page
1/68
Next page
66
A1
A2
2.
1.
A1
A3
A2
A2
A1
4.
3.
A3
A2
<
1,5 mm / 10 m = OK
Cuando en los ejes X, Y o Z los puntos A2 y A3 estén separados más
de 1,5 mm / 10 m, será necesario un nuevo ajuste. Póngase en contacto
con su distribuidor especializado o diríjase al Servicio Técnico de
UMAREX-LASERLINER.
!
Comprobar la calibración
3. Ponga el aparato lo más cerca posible de la pared, a la altura del punto
A1 marcado.
4. Gire el aparato 180° y marque el punto A3. La diferencia entre A2 y A3
es la tolerancia.
5. Repita los puntos 3 y 4 para la comprobación del eje Y y Z.
Preparativos para la comprobación de la calibración
Usted mismo puede comprobar la calibración del láser. Coloque el aparato
en el medio entre 2 paredes, separadas como mínimo 5 m. Encienda el
aparato. Para una comprobación óptima, por favor utilice un trípode / soporte.
IMPORTANTE: la automática de sensor tiene que estar activada (LED de
auto/slope apagado).
1. Marque el punto A1 en la pared.
2. Gire el aparato 180° y marque el punto A2. Ahora tiene una referencia
horizontal entre A1 y A2.
ES
… 66


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner Cubus G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner Cubus G in the language / languages: English, German, Dutch, Danish, French, Spanish as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info