646716
23
Zoom out
Zoom in
Previous page
1/68
Next page
Cubus / Cubus G
23
Y
Z
X
X- / Y- /
Z-Axis
Regularly check the adjustment before
use, after transport and after extended
periods of storage. Always make sure
to control all axes.
!
Adjustment mode
Take the alignment of the rotary laser into account when
performing adjustment work. Always adjust all the axes.
X axis adjustment
Activate adjustment mode: Switch on the Cubus. Simultaneously
press the ON/OFF button and the auto/slope button until the tilt LED
flashes rapidly.
Switch to the X axis using the tilt button. (LED auto/slope)
Adjustment: Use the positioning buttons to move the laser from its
current position to the height of reference point A2.
Cancel adjustment: Switch the device off.
Save: Pressing the scan button saves the new adjustment settings.
Adjust the Y and Z axes
Activate adjustment mode: Switch on the Cubus. Simultaneously
press the ON/OFF button and the auto/slope button until the tilt LED
flashes rapidly.
Adjustment: Use the positioning buttons to move the laser from its
current position to the height of reference point A2.
Cancel adjustment: Switch the device off.
Save: Pressing the scan button saves the new adjustment settings
To adjust the Z axis, set up the device vertically
and proceed in the same manner as for the
X axis adjustment.
GB
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner Cubus G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner Cubus G in the language / languages: English, German, Dutch, Danish, French, Spanish as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info