646716

Laserliner Cubus G Manual

19
Zoom out
Zoom in
Previous page
1/68
Next page
Cubus / Cubus G
19
auto auto
If the device has been placed on a surface with a slope of more than
4°, the prism head will remain stationary and the laser as well as the
auto/slop LED will start to flash. The device must then be placed on a
more even surface.
!
auto/slope function LED OFF: Automatic alignment
!
– The device levels itself automatically to within a range of ± 4°. During the
set-up phase, the laser flashes and the prism head remains stationary. When
levelling is complete, the laser lights up continuously and rotates at maximum
speed. Refer also to the sections about „Sensor Automatic“ and „ADS Tilt“.
Horizontal levelling and vertical levelling
– Horizontal: Position the device on a level surface or
on a tripod.
– Vertical: Place the device on its side with the stand
and wall bracket fitted. The operator panel should
be at the top. The device with the stand and wall
bracket can be mounted on a tripod for vertical use.
– Press the „ON/OFF“ switch
man
Auto/slope function LED ON: Manual alignment
!
Slope function
Steeper slopes can be set using the angle plate,
which is available as an optional extra
(product ref. 080.75).
TIP: Allow the device to align itself automatically
and set the angle plate to the zero position.
Then press the auto/slope button to switch the
automatic sensor off. Finally, incline the device
to the angle you require.
GB
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner Cubus G at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner Cubus G in the language / languages: English, German, Dutch, Danish, French, Spanish as an attachment in your email.

The manual is 1,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info