646117

Laserliner CombiFinder Plus Manual

8
Zoom out
Zoom in
Previous page
1/92
Next page
08
B
C
7
4
A
GB
Tip 1: Manual calibration should be performed near the place found last as shown in
Image B/C. Repeat this step as needed.
Tip 2: Because of static charges, electric fields may be detected at the side of the actual
position of the wire. To carry away these charges, lay your free hand on the wall.
Tip 3: Move the tool slowly as friction can generate interfering electric charges.
Manual
calibration
Isolate an object to be
measured by passing
over it several times.
Manual
calibration
For localising live wires directly beneath the plaster or behind wooden panels and other
non-metallic panelling. It is not possible to detect live wires in dry walls with metal studs.
– Select AC-SCAN (button 4).
– As soon as the display switches from CAL to CAL OK, you can move the device.
– MOVE: Move the tool slowly across the surface.
Measuring in AC-SCAN mode
Tip 2: The position where you start is important: First place the device in a position
where you know there is no metal. Otherwise, the message “ERROR” will appear
in the display. To remedy: Move the device to another position a few centimetres
away and start measuring again.
Tip 3: In the case of complicated applications, e.g. ribbed steel, scan the surface both
horizontally and vertically.
Tip 4: Flexible floor and wall heating pipes which contain a metal foil and are located
near the surface may also be detected. Test for this function in places where you
know the position of such pipes.
Tip 5: To avoid interference while scanning, keep your free hand and other objects at
least 15 cm away from the device.
Tip 6: The device only finds the outer edge of metal structures set into the wall for
doors, windows and corners. Afterwards search for the other edge of the metal
structure. Slide the device sideways across the wall. When the maximum indication
appears you have reached the metal structure‘s edge.
Tip 7: Ensure that you have really detected a metal object. To do so, check on both
sides whether other metal objects are present at equal distances, usually at 30, 40
or 60 cm. Also check that it is a metal object by scanning at several places directly
above and below the position of the first find.
Tip 8: Textured ceilings: The ceiling must be covered with cardboard to protect it.
In this case, perform detection with maximum sensitivity, i.e. calibrate the device
in mid-air.
Note: If an object is deep inside a wall, the device may not indicate it clearly.
Manual_CombiFinder-Plus_Rev.1212.indd 08 08.01.13 11:33
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Laserliner CombiFinder Plus at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner CombiFinder Plus in the language / languages: All languages as an attachment in your email.

The manual is 1,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info