Manual Laserliner BeamControl-Master BCM (page 17 of 92) (English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish)

646162

Zoom out

Zoom in

1/92

BeamControl-Master BCM

ENGLISH

< 2 mm / 10m = OK

Preparing the calibration check

It is possible for you to check the calibration of the laser. To do this, position the device

midway between 2 walls, which must be at least 5 metres apart. Switch the unit on

and use the SensoLite to define the marking points. For optimum results, please use a

tripod.

1. Mark point A1 on the wall. (Use spot mode.)

2. Turn the device through 180° and mark point A2. You now have a horizontal

reference between points A1 and A2.

Performing the calibration check

3. Position the device as near as possible to the wall at the height of point A1. Now

adjust the device in the X axis.

4. Turn the device through 180° and mark point A3. The difference between points A2

and A3 is the tolerance for the X axis.

5. To check the Y axis, repeat steps 3 and 4.

Note: Mark either levelling screw A or B as a reference screw. Align the unit only with

the other levelling screws.

Note: If points A2 and A3 are more than 0,5 mm / 10 m apart on either the X or Y

axis, the device is in need of calibration. Contact your authorised dealer or else the

UMAREX-LASERLINER Service Department or follow the calibration instructions in the

manual.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Laserliner BeamControl-Master BCM in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 2,53 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Laserliner BeamControl-Master BCM Manual

Product: