Manual Laica BC1005 (page 6 of 18) (English, German, French, Italian, Portuguese, Spanish)

677501

Zoom out

Zoom in

1/18

12 13

ELECTRIC STEAM STERILISER

BEFORE USING THE PRODUCT, IT IS IMPORTANT TO READ THE

INSTRUCTIONS AND WARNINGS CONTAINED IN THIS BOOKLET

CAREFULLY. PRESERVE THIS BOOKLET WITH CARE.

Taking care of newborns requires utmost hygiene of the necessary accessories

for nursing since poor attention to this may result in stomach ache or diarrhoea.

Among the household methods applied for assuring a suitable hygienic level,

the use of heat is surely the most interesting one.

By means of the steam generated by a hot source, it is possible to reach

such a cleanness level allowing considering most of the germs noxious for

newborns eliminated.

Assuming this, LAICA offers a simple and safe system for sterilizing feeding

bottles and all their components.

Your new sterilizer can sterilize up to 6 bottles in about 10 minutes.

It is equipped with an internal basket for sterilizing teats.

The device is equipped with a dosing measuring scoop and hygienic tweezers

to handle the sterilised accessories.

Mains operation.

GENERAL WARNINGS

The use of any electric device involves the respect of some essential rules:

• Disconnect the plug from the power outlet immediately after use, and in

any case always before cleaning it and before inserting or removing the

accessories.

• Do not pull the power supply cable or the device itself to disconnect the

plug from the power outlet.

• If an electric device falls into water do not attempt to reach it, but rather

immediately disconnect the plug from the power outlet.

• Never immerse the device in water or other liquids.

• Never let the device work unattended and do not allow children, invalid or

disabled people to use it.

• This device shall be used only for the use destination for which it was

designed, and in the way described in the instructions for use.

Any other use is to be considered improper and therefore dangerous.

The manufacturer cannot be made liable for any damages resulting from

improper or wrong use.

• Before use, make sure that the device is integral, without visible damages.

In case of doubt, do not use the device and refer to the own dealer.

• In case of fault and/or malfunction, immediately switch off the device without

tampering it.

For the repairing, always refer to the own dealer.

• Keep the device away from heat sources.

• Make sure to have dry hands when inserting and removing the plug and

when acting on the ON/OFF key.

• This device has to be used only with the voltage values given on the bottom

of the product.

• Do not leave the device exposed to weathering (rain, sun, etc.), high

temperatures or close to computers or other electronic devices.

• To avoid dangerous overheating, it is recommended to unwind the power

supply cable for its entire length.

• Disconnect the plug from the power outlet when the device is not in use.

• Caution! Do not intervene for any reason whatsoever on the electric cable.

In case of damage, refer to the own dealer.

SPECIAL WARNINGS

• When operating, the sterilizer contains boiling water and steam

that comes out from the cover. Watch out in order to avoid burns.

• Place the device on a flat, rigid and water-proof surface; keep the power

supply cable away from heat sources.

• Do not open the unit when it is working in order to avoid burns.

• Do not use the steriliser without water; use only cold tap water without

adding any essence, perfume, medicine or other substances.

• Do not sterilise metal objects.

• Do not cover or insert objects into the openings of the steam steriliser (e.g.

into the steam outlet hole on the cover, into the bottom of the device).

• Caution! This is not a toy, but a household steam steriliser.

Do not leave the device unattended also when it is not used.

DEVICE PARTS

1. Steriliser unit

2. Water container

3. O/I light

4. Steriliser unit cover

5. Teat and bottle holding basket

6. Dosing measuring scoop

7. Hygienic tweezers

8. Power supply cable

INSTRUCTIONS FOR USE STEAM STERILIZER:

Before using the steriliser for the first time:

1) Place the device on a flat and stiff surface.

2) Assemble the teat and bottle holding basket according to figure 1. Insert

and embed the appropriate supports to the base as shown in fig. 1a, 1b

and 1c.

3) Pour exactly 60 ml of cold tap water into the device water tray using the

measuring scoop included in the supply (figure 2).

4) Place the basket and the hygienic tweezers into the steriliser (see figure

3). Close the cover.

5) Connect the plug and press the O/I button.

The O/I light turns on (red).

Caution! If the O/I light turns on immediately after you insert the plug, it

means that the O/I button was accidentally pressed before connecting the

plug. In this case, the device starts automatically the sterilization cycle.

Do not turn the device on, if the water tank in the base has not been filled

first.

6) After each sterilisation cycle, the red light switches off indicating that the

sterilisation has ended.

In any case, switch off the device disconnecting the plug from

the outlet.

7) Let the steriliser cool down for few minutes, open the cover, extract the

teat basket and the hygienic tweezers, remove any excess water from

inside the steriliser unit, drying the same with a clean cloth. Now your

new steam steriliser is ready for use.

Caution! Before performing the steam sterilisation, verify that the

baby bottles and nursing accessories can be boiled.

The steam steriliser can sterilise up to 6 baby bottles simultaneously.

1) Place the device on a flat and stiff surface.

2) Pour exactly 60 ml of cold tap water into the device water tray using the

measuring scoop included in the supply (figure 2).

Caution! If a greater quantity of water is poured, the sterilisation cycle may

last longer; if the quantity is lower, the sterilisation may be ineffective.

3) Place the baby bottles upside down in vertical position inside the steriliser

leaning them on the lower tray of the bottle holding basket (figure 4) and

place the related teats or any small parts to be sterilised on the upper basket.

Place the hygienic tweezers on the upper tray among the teats.

Close the cover.

Caution! Wash all baby bottles and accessories with non-foamy

soap carefully and rinse them with plenty of water before each

sterilisation cycle.

4) Connect the plug and press the O/I button.

The O/I light turns on (red).

Caution! If the O/I light turns on immediately after you insert the plug, it

means that the O/I button was accidentally pressed before connecting the

plug. In this case, the device starts automatically the sterilization cycle.

Do not turn the device on, if the water tank in the base has not been filled

first.

5) After few minutes, steam comes out from the hole on the cover, watch out

to avoid burns.

6) After about 10 minutes, the red light switches off: the sterilisation has ended.

In any case, switch off the device disconnecting the plug from

the outlet.

7) Do not remove the cover immediately; let the steriliser cool down for few

minutes.

8) Wash your hands carefully before picking up the sterilised products.

9) Open the cover, take the hygienic tweezers that can be used to pick up the

sterilised teats and place them on the baby bottles.

English English

Instructions and guarantee

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Laica BC1005 in the language / languages: English, German, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 0,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Laica BC1005 Manual

Product: