812600
6
Zoom out
Zoom in
Previous page
1/36
Next page
MANUAL FOR USE AND MAINTENANCE
6 LSC 001 -UK- REV. 06
1.5
INSTALLATION REQUIREMENTS FOR THE USER
The machine has to be placed on a stable at
surface that can guarantee a safe position. Check
this important requirement, since the manufacturer
cannot be considered liable for any damage caused
by the instability of the appliance. While preparing
the systems, take into account that a hole is needed
in the bearing surface in order to make all electric and
water connections through the opening below where a
water softener will need to be tted, if recommended
by the installation engineer.
A hole of 10 x 10 cm is enough in the area (a) as
indicated in Pict. 1.
The machine needs a minimum clearance of:
- height cm. 60
- width cm. 40
- depth cm. 40
Between the water mains and the water inlet pipe of the appliance, there must be a tap to stop the water
ow if necessary (2 - Pict.1).
The water mains pressure must be within the range of 1 and 5 bar.
If this requirement is not met, please consult the manufacturer.
The appliance is supplied without a plug. It is supposed to be directly connected to the electric mains and
therefore, it is necessary to t a single-pole switch with contact opening of 3 mm or more beforehand,
according to the regulations in force (1 - Pict.1).
The drainpipe of the appliance must be directly connected to a suitable open drain siphon, previously
installed by the customer (3 - Pict.1).
Do not t the drain pipe into basins or buckets placed under the counter as this will increase the possibility
of forming dirt deposits and as a result, the spread of bacteria.
WARNING!
For appliances operating with gas, the gas supply tap must be tted in an easily accessible place
(4 - Pict.1), so as to be able to shut off the gas supply if necessary.
Regularly check the expiry date on the gas pipe connecting the system and the appliance and have
it replaced by the Service Centre before this date.
WARNING!
The appliance is supplied without water in the boiler. This is to prevent serious damage if the
appliance is exposed to low temperatures.
The appliance must only be supplied with cold drinking water.
1
2
3
x
Single pole switch with an opening of at least 3 mm between
contacts
Water supply tap
Drain siphon
Gas supply tap (if tted)
y
z*
*) Distance between the back of the appliance and
the wall.
min. 20 cm.
min. 40 cm.
min. 10 cm.
4
Y
X
4
1
a
2
3
X
001
1
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for La Spaziale RAPID at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of La Spaziale RAPID in the language / languages: English as an attachment in your email.

The manual is 1.91 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info