20377
67
Zoom out
Zoom in
Previous page
1/110
Next page
Chapter 1 Using the Operator Panel
1-57
Follow the procedure given below to change the recovery
time for Auto Continue.
Press the MENU key.
Press the or key repeatedly until Others > ap-
pears.
Press the key.
Press the or key repeatedly until >Auto
Continue Mode > appears.
Press the key and display >>Auto Continue
Timer.
Press the ENTER key. A blinking cursor (_) appears.
Press the or key to increase or decrease the val-
ue of the figure where the cursor is blinking and set
the desired time. The time must be set between 000
and 495 seconds, in 5-second increments. If set to
000, printing will be continued immediately without
allowing any time interval. You can use the and
keys to move the cursor right and left.
Display the desired time and press the ENTER key.
Press the MENU key. The message display returns to
Ready.
Setting the Auto Continue Recovery Time
Others >
>Auto Continue >
Mode On
>>Auto Continue
Timer 030
Sec.
1
2
3
4
5
6
7
8
9
67


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kyocera FS6020 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kyocera FS6020 in the language / languages: English as an attachment in your email.

The manual is 4,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info