522405
26
Zoom out
Zoom in
Previous page
1/38
Next page
25
If you set up the system for DISH Network or
ExpressVu, follow these steps to run the
receiver’s Check Switch test to configure the
receiver for the desired satellites.
NOTE: If you are connecting multiple receivers,
repeat this process for each additional receiver. You
will need to connect each receiver, one at a time, to the
“RF1” cable and perform the steps below. Then, once
you have completed this process for each receiver, you
can reconnect them as desired.
a. Dock the vessel and ensure the antenna has
an unobstructed view of the sky.
b. Ensure the receiver is connected to the “RF1”
cable (see Figure 22 on page 12 (circular/Sky
Mexico) or Figure 23 on page 13 (linear)).
c. Apply power to the TV and receiver. (If the
antenna is turned off, turn it back on and wait
until the MCP shows “Tracking.”)
d. Using the receiver remote, go to the “Point
Dish/Signal Strength” screen (press MENU,
6, 1, 1 on most models).
e. Choose Check Switch, then press SELECT.
f. Choose Test, then press SELECT.
g. When the MCP no longer shows “Check
Switch Running,” refer to the tables in
Figure 41 to verify the values displayed on
your TV match those required for your
selected service. If your values do not match:
Turn off the antenna, then turn it back on and
repeat Steps d-f. When the MCP shows
“Please Run Check Switch,” repeat Steps d-f
again to run a second Check Switch.
h. Exit the menu and allow the receiver to
download the program guide.
This procedure must be performed while the
vessel is docked in calm water.
IMPORTANT!
Please be patient. The Check Switch test takes
approximately 15 minutes to complete.
Disregard any messages on the TV; they do
not correctly indicate the status of the test.
IMPORTANT!
Figure 41: Expected Check Switch Results Displayed on TV
DISH 1000/129 Results
DISH 1000/61 Results
DISH 500 Results
ExpressVu Results*
* If you installed just one ExpressVu satellite, the TV will show
an error message instead. This is normal.
Port 123
Satellite 119 110 129
Trans OKOKOK
Status Reception Verified
Switch SW64
Port 123
Satellite 119 110 61
Trans OKOKOK
Status Reception Verified
Switch SW64
Input 1122
Satellite 119 119 110 110
Polarity Odd Even Odd Even
Status Reception Verified
Switch SW42
Input 1122
Satellite91918282
Polarity Odd Even Odd Even
Status Reception Verified
Switch SW21
Run a Check Switch Test
17
DISH Network or ExpressVu Only
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KVH TracVision M7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KVH TracVision M7 in the language / languages: English as an attachment in your email.

The manual is 4,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KVH TracVision M7

KVH TracVision M7 User Manual - English - 81 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info