522403
29
Zoom out
Zoom in
Previous page
1/65
Next page
TracVision M3/M2 User’s Guide
31
Chapter 4 - Setup
Setting the LNB Skew Angle
To optimize reception, the antenna’s LNB (low-noise block) must be
set to the correct skew angle for the satellite(s) you want to track.
Follow the steps below to set the antenna’s LNB skew angle.
1. First determine what the correct skew angle should be
for your selected satellite(s) and position. You can find
the correct skew angle by either reading the system
startup screens (see “System Startup” on page 13) or
running the Diagnostics test (see “Running the
Diagnostics Test” on page 42).
Check the reported latitude/longitude as well. If the
interface box reports a latitude/longitude that is more
than 600 km (400 mi) away from your vessel’s actual
position, you should re-enter your position into the
interface box to obtain a more accurate skew angle. See
“Entering Latitude/Longitude” on page 22.
Figure 10 Latitude/Longitude Reported During System Startup
Figure 11 Skew Angle Reported During System Startup
2. Turn off and unplug your satellite TV receiver.
3. Press the POWER switch on the front of the
TracVision interface box to turn off the TracVision
system. Make sure the VOLTAGE light goes out.
CAUTION
Disconnect power from the antenna before you remove the
radome. The antenna has moving parts that can cause
injury.
LAT/LONG: 55N, 012E
AVERAGE SKEW:-12.3
CHECK LNB SETTING
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for KVH TracVision M2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of KVH TracVision M2 in the language / languages: English as an attachment in your email.

The manual is 4,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of KVH TracVision M2

KVH TracVision M2 Installation Guide - English - 17 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info