653336
9
Zoom out
Zoom in
Previous page
1/23
Next page
17
16
HOW TO DISASSEMBLE AND CLEAN
Note |
Place the juicing bowl under running
water and unplug the compression
silicone to clean the pulp spout.
Soak the juicing bowl in a solution of
warm water with baking soda or little bit
of bleach to clean the excess build up.
Tip |
It is not necessary to completely
clean the juicer in between making
multiple juices during a single juicing
session.
• When nished with juicing, always
disassemble and clean thoroughly
between juicing sessions to prevent
residue buildup.
Tip |
Clean the base with a soft damp towel
and dry.
Note |
Remove the juicing screw, strainer and
rotation wiper unit from the juicing bowl.
Clean with provided brush.
Note |
Note |
Tip |
Note |
Under running water, clean the outside
of the juicing screw with a dish scrub. Use
the tip of the cleaning brush to push out
any residue in the crevices on the bottom
of the juicing screw.
With the smart cap closed,  ll the
juicing bowl with water and turn on
the juicer.
Let it run for a moment. Open the
smart cap and let the water run out
of the juicing bowl.
If the towel is dripping wet, make sure
to squeeze out the excess liquid before
using it on the juicer.
After juicing ingredients with seeds, make
sure to thoroughly clean the bottom
crevice of the juicing screw. If this area
isn’t properly cleaned, it can a ect the
balance between the juicing screw and
the strainer and damage the parts.
Extract all the remaining pulp in the
juicing bowl before stopping the juicer.
For easier clean up, operate the juicer for
an additional 30 seconds after the juice is
extracted.
When the drum lid is stuck, press the
REVERSE – OFF – FORWARD button in
this order, switching back and forth 2 to
3 times to dislodge. Then place hands
on top of the drum lid and firmly press
down simultaneously turning the drum
lid counter clockwise to open.
Thoroughly clean the juicing screw
ensuring that the juicing screw is clean
without any residue.
Completely dry before using.
Immediately clean the juicer after each
use. If remaining residue in the juicer dries
up, it can make disassembling and clean-
up di cult. The excess build up can cause
poor performance in future uses.
For easier disassembly, place the top-
set in the sink and run the water through
from the top of the top-set.
Thoroughly dry the bottom of the juicing
screw where it connects to the metal
cylinder shaft on the base.
Switch OFF and unplug the power cord
from the wall outlet.
1
1 4 6
75
1
2
* The products illustrated/photographed in this booklet may vary slightly from the actual product.
Quick Rinsing
Turn the drum lid counter clockwise to
open.
Turn the top-set counter clockwise and lift
o the base.
When moving the appliance, do not lift by
grabbing the feeding tube. Always lift the
appliance by grabbing the base or handle.
2
3
EN
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kuvings ULD-115YB at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kuvings ULD-115YB in the language / languages: English as an attachment in your email.

The manual is 1,37 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info